FT4232HQ_MINI MOD FTDI, Future Technology Devices International Ltd, FT4232HQ_MINI MOD Datasheet - Page 12
![MODULE EVAL USB FT4232HA HS](/photos/9/3/90382/ft2232hq_mini_mod_sml.jpg)
FT4232HQ_MINI MOD
Manufacturer Part Number
FT4232HQ_MINI MOD
Description
MODULE EVAL USB FT4232HA HS
Manufacturer
FTDI, Future Technology Devices International Ltd
Datasheet
1.FT4232HQ_MINI_MOD.pdf
(13 pages)
Specifications of FT4232HQ_MINI MOD
Main Purpose
Interface, USB 2.0 to UART (RS232) Bridge
Embedded
Yes, ASIC
Utilized Ic / Part
FT4232H
Primary Attributes
High-Speed, 300 baud ~ 12 Mbaud, Security ID Number
Secondary Attributes
Emulates JTAG, SPI, I2C, Bit-bang or Other Synchronous Serial
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
768-1031
FT4232HQ_MINI MOD
FT4232HQ_MINI MOD
Appendix A – FT4232H EEPROM Configuration
The FT4232H Mini Module utilizes an EEPROM which contains the USB configuration descriptors for the
FT4232H. When the Mini Module is plugged into a PC or a USB reset is performed, the PC will read these
descriptors. The default values stored into the EEPROM are defined in Table 6.1.
Parameter
USB Vendor ID (VID)
USB Product UD (PID)
Serial Number Enabled?
Serial Number
Pull down I/O Pins in USB
Suspend
Manufacturer Name
Product Description
Max Bus Power Current
Power Source
Device Type
USB Version
Remote Wake Up
High Current I/Os
Load VCP Driver
Table 6.1 Default Internal EEPROM Configuration
The EEPROM on the FT4232H Mini Module can be re-programmed over USB using the utility program
MPROG. MPROG can be downloaded from the www.ftdichip.com. Version 3.5 or later is required for the
FT4232H chip. Users who do not have their own USB Vendor ID but who would like to use a unique
Product ID in their design can apply to FTDI for a free block of unique PIDs. Contact FTDI support for this
service.
Copyright © 2010 Future Technology Devices International Limited
Value
0403h
6011h
Yes
See Note
Disabled
FTDI
FT4232H_MM
500mA
Bus Powered
FT4232
0200
Enabled
Enabled
Disabled
FT4232H Mini Module USB Hi-Speed FT4323H Evaluation Module
Notes
FTDI default VID (hex)
FTDI default PID (hex)
A unique serial number is generated and programmed into
the EEPROM during device final test.
Enabling this option will make the device pull down on the
UART interface lines when the power is shut off (PWREN#
is high).
Returns USB 2.0 device description to the host.
Note: The device is be a USB 2.0 Full Speed device
(12Mb/s) as opposed to a USB 2.0 High Speed device
(480Mb/s).
Taking RI# low will wake up the USB host controller from
suspend.
Enables the high drive level on the UART and CBUS I/O
pins.
Makes the device load the VCP driver interface for the
device.
Document Reference No.: FT_000115
Clearance No.: FTDI#73
Datasheet Version 1.6
10