V2-EVAL FTDI, Future Technology Devices International Ltd, V2-EVAL Datasheet - Page 47

• Manufacturer Part Number: V2-EVAL
• Description: BOARD DEV FOR VINCULUM-II VNC2
• Manufacturer: FTDI, Future Technology Devices International Ltd
• Series: Vinculum-IIr

Specifications of V2-EVAL

• Main Purpose: USB Controller
• Embedded: Yes, ASIC
• Utilized Ic / Part: VNC2-32Q
• Primary Attributes: 1 type-B and 2 type-A USB connectors
• Secondary Attributes: User Configurable LEDs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 768-1062

8.2
The V2-EVAL terminal utility is a standard terminal application designed specifically to support the V2-
EVAL board. The application provides communication to the UART interface on the VNC2 device and also
provides commands to control some basic configuration functions on the V2-EVAL board. All
communication and control commands are directed to the V2-EVAL board via the onboard FT4232H USB
to quad channel serial converter.
Figure 8.2: V2-EVAL Terminal Utility Features
The V2-EVAL utility supports standard terminal commands and control functions. Pull down menus list
different UART speeds, and data settings. On the top right hand section of the software a set of check
buttons are available for controlling the V2-EVAL board. A summary of the function of each button on the
V2-EVAL terminal utility is outlined below:
settings - pull
or text format
down menu
Tabs to select
Connection
between hex
Connect
console
button
display
„Connect’ button – Connects and disconnects the terminal utility from the UART hardware.
„Assert RTS’ checkbox – Assert the Request To Send line on the UART interface.
‘Asset DTR’ checkbox – Assert Data Terminal Ready line on the UART interface.
‘UART’ mode button – Enables full UART TX and RX operation through the V2-EVAL terminal
utility. Under the UART mode the select line of the V2-EVAL board multiplexer U4 is set to „0‟
forcing the FT4232H channel A to connect to UART interface on VNC2, as per the conditions
outlined in Table 6.1.
„Spy’ mode button – The „Spy‟ button sets the select line of the V2-EVAL board multiplexer U4 to
„1‟, allowing the VNC2 UART interface to be controlled by an external device connected to the V2-
EVAL board instead of the FT4232H, as per the conditions outlined in Table 6.1. Under this setting
a user can connect to V2-EVAL board in „Spy‟ mode via FT4232H channel C and observe VNC2
UART RX data in the terminal utility. „Spy‟ mode is a read-only UART mode. Any user data input
to the console under this mode is ignored.
‘Assert RESET’ checkbox – When checked the software will enable the RESET# input signal on
the VNC2 device. The checkbox is only available under UART mode.
‘Assert PROG’ checkbox - When checked, the software will enable the PROG# input signal on
the VNC2 device. The checkbox is only available under UART mode.
Using V2-EVAL Terminal
Copyright © 2010 Future Technology Devices International Limited
UART console input and output area
Standard UART terminal control
functions
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Document Reference No.: FT_000247
V2-EVAL specific board
Clearance No.: FTDI#148
functions
46