SI3050PPT2-EVB Silicon Laboratories Inc, SI3050PPT2-EVB Datasheet - Page 5

• Manufacturer Part Number: SI3050PPT2-EVB
• Description: BOARD EVAL FOR DAA SI3050/SI3008
• Manufacturer: Silicon Laboratories Inc

Specifications of SI3050PPT2-EVB

• Main Purpose: Telecom, Data Acquisition Arrangement (DAA)
• Utilized Ic / Part: Si3050
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4. Evaluation Software
The Si3050PPT-EVB includes an easy-to-use graphical
interface for controlling the evaluation platform. This
software allows the system designer to characterize the
Si3050 DAA performance without constructing any
custom hardware. The evaluation software includes the
following features:
4.1. PC System Requirements
The application software for the Si3050PPT-EVB has
the following system requirements:
4.2. Installation
The supplied CD contains the Si3050PPT-EVB windows
driver files as well as a setup utility for installing the
evaluation software.
To install the Si3050PPT-EVB software, run the
installation program on the “Silicon Laboratories
Wireline Software CD.” The path for the installation
program is Si3050 Evaluation Software\setup.exe. The
installer guides the user through the installation process
for Si3050PPT-EVB.exe and the LabVIEW Run-Time
engine.
Ability to read and write DAA registers using the SPI
or GCI bus
DAC waveform generation from a series of standard
waveforms or from a .wav file
ADC data capture and display in either the time or
frequency domain using either PCM or GCI bus
Daisy-chain support
Transmit and receive path attenuation and gain
settings
Ring detection
Loop current measurement
Windows98®, Windows2000®, or WindowsXP®
Available parallel port
WindowsXP
450 MHz Pentium II® or greater recommended
64 MB of memory or greater recommended
EPP or ECP parallel port mode for Windows 98®
EPP parallel port mode for Windows 2000® and
®
Rev. 1.0
5. Using the Si3050PPT-EVB
A shortcut for starting the application software that
controls the Si3050PPT-EVB is installed in the Windows
Start Menu under the Programs folder in the “Si3050
Evaluation Software” folder.
5.1. Application Menus
Three pulldown menus are used to configure the
operation of the software:
Run:
Configure:
configuration. User can set advanced software options.
initialization sequences on Reg 1, Reg 5–7, Reg 33–37,
and Reg 42
Design Tool
Si3050 and Si3019.
over frequency
Help: Displays information about the evaluation
board
Application Software
Transhybrid Loss Calculation: Calculate transhybrid loss
Exit: Stops the program
Save: Stores the audio waveform into .wav files
Configure DAA: Display hardware status and user
Reset DAA: Resets DAA and executes basic
Register Map: Displays Register Map of Si3050
Signal Flow Diagram: Displays Signal Flow Diagram of
Ringing: Help user program ring validation registers.
Si3050PPT-EVB
5