LMX25311146EVAL National Semiconductor, LMX25311146EVAL Datasheet - Page 28

• Manufacturer Part Number: LMX25311146EVAL
• Description: BOARD EVAL FOR LMX25311146
• Manufacturer: National Semiconductor
• Series: PowerWise®r

Specifications of LMX25311146EVAL

• Main Purpose: Timing, Frequency Synthesizer
• Utilized Ic / Part: LMX2531LQ1146E
• Silicon Manufacturer: National
• Silicon Core Number: LMX2531
• Kit Application Type: Clock & Timing
• Application Sub Type: Frequency Synthesizer
• Kit Contents: Board, Cable, CD
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed

2.6 REGISTER R5
2.6.1 EN_PLL -- Enable Bit for PLL
When this bit is set to 1 (default), the PLL is powered up, otherwise, it is powered down.
2.6.2 EN_VCO -- Enable Bit for the VCO
When this bit is set to 1 (default), the VCO is powered up, otherwise, it is powered down.
2.6.3 EN_OSC -- Enable Bit for the Oscillator Inverter
When this bit is set to 1 (default), the reference oscillator is powered up, otherwise it is powered down.
2.6.4 EN_VCOLDO -- Enable Bit for the VCO LDO
When this bit is set to 1 (default), the VCO LDO is powered up, otherwise it is powered down.
2.6.5 EN_PLLLDO1 -- Enable Bit for the PLL LDO 1
When this bit is set to 1 (default), the PLL LDO 1 is powered up, otherwise it is powered down.
2.6.6 EN_PLLLDO2 -- Enable Bit for the PLL LDO 2
When this bit is set to 1 (default), the PLL LDO 2 is powered up, otherwise it is powered down.
2.6.7 EN_DIGLDO -- Enable Bit for the digital LDO
When this bit is set to 1 (default), the Digital LDO is powered up, otherwise it is powered down.
2.6.8 REG_RST -- RESETS ALL REGISTERS TO DEFAULT SETTINGS
This bit needs to be programmed three times to initialize the part. When this bit is set to one, all registers are set to default mode,
and the part is powered down. The second time the R5 register is programmed with REG_RST=0, the register reset is released
and the default states are still in the registers. However, since the default states for the blocks and LDOs is powered off, it is
therefore necessary to program R5 a third time so that all the LDOs and blocks can be programmed to a power up state. When
this bit is set to 1, all registers are set to the default modes, but part is powered down. For normal operation, this bit is set to 0.
Note that once this initialization is done, it is not necessary to do this again unless power is removed from the device.
www.national.com
28