ADC14DS105KARB/NOPB National Semiconductor, ADC14DS105KARB/NOPB Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/4/469/national_semiconductor_sml.jpg)
ADC14DS105KARB/NOPB
Manufacturer Part Number
ADC14DS105KARB/NOPB
Description
BOARD EVAL FOR ADC14DS105KARB
Manufacturer
National Semiconductor
Series
PowerWise®r
Specifications of ADC14DS105KARB/NOPB
Design Resources
ADC14DS105KARB Ref Design
Number Of Adc's
2
Number Of Bits
14
Sampling Rate (per Second)
105M
Data Interface
Serial
Inputs Per Adc
1 Differential
Power (typ) @ Conditions
1W @ 105MSPS
Voltage Supply Source
Single Supply
Operating Temperature
-40°C ~ 85°C
Utilized Ic / Part
ADC14DS105
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
ADC14DS105KARB
3. Plug the PIC microcontroller board onto the dual-
N
Figure 5. PIC microcontroller Board Connection and
row header labeled “UWIRE” as shown in Figure 5.
Align the arrows on the two boards to ensure
proper orientation. JP1 should have a jumper
installed on the main board to provide power to the
PIC microcontroller board. Lastly, flip the switches
on the PIC microcontroller board to the following
positions: Switch 1 = OFF, Switch 2 = OFF.
Place JP1 on
main board to
provide power
to PIC board
Figure 4. Connection Diagram for ADC14DS105KARB and WaveVision 5.1 Data Capture Hardware
Configuration
Switch 1 = OFF
Switch 2 = OFF
Align Arrows
ADC14DS105KARB Reference Design Board User’s Guide
- 7 -
4. Connect a 5.0V dual power supply (+/- 5.0V)
5. The single-ended analog signal inputs are provided
6. Set the signal source to the desired frequency (up
7. Press
capable of supplying up to 1A to the green power
connector which is located along the bottom edge
of the ADC14DS105KARB board. This is shown in
Figure 3.
going to the green power connector match the
“+5V”, “-5V” and “GND” labels on the evaluation
board. Turn on the +/- 5V supply.
by board-edge SMA(f) connectors labeled “INA”
and “INB”. The input impedances are 50 ohms.
The maximum amplitude (Vp-p) for satisfactory
performance is 1 Vp-p. The inputs are DC-coupled
but the input signal may be either DC or AC
coupled. If DC coupled, the DC level of the signal
should not exceed 1.2 V. The DC level is set on
the ADC14DS105KARB reference board. Connect
the signal source through the SMA connector as
shown in Figure 1 and Figure 4. Recommended
signal generators are the HP8644B (HP/Agilent) or
the SMA100A (Rohde & Schwarz). A bandpass
filter between the signal generator output and the
ADC14DS105KARB SMA connector is required to
measure the true performance of the board. See
Figure 4.
to ~35 MHz) and the input amplitude to 0dBm. The
signal generator amplitude will need to be adjusted
during evaluation to obtain the desired signal
amplitude at the ADC input.
microcontroller board to load the register settings
the
Ensure that the polarity of the wires
“RESET”
button
www.national.com
on
the
Rev 0.2
PIC