STEVAL-CCA012V1 STMicroelectronics, STEVAL-CCA012V1 Datasheet - Page 24

• Manufacturer Part Number: STEVAL-CCA012V1
• Description: BOARD EVAL BASED ON TS2007
• Manufacturer: STMicroelectronics

Specifications of STEVAL-CCA012V1

• Amplifier Type: Class D
• Output Type: 1-Channel (Mono)
• Max Output Power X Channels @ Load: 2.8W x 1 @ 4 Ohm
• Voltage - Supply: 2.4 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Board Type: Fully Populated
• Utilized Ic / Part: TS2007
• Description/function: Audio Amplifiers
• Operating Supply Voltage: 2.4 V to 5.5 V
• Output Power: 3 W
• Product: Audio Modules
• Silicon Manufacturer: ST Micro
• Silicon Core Number: TS2007
• Kit Application Type: Amplifier
• Application Sub Type: Audio Power Amplifier
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: TS2007
• Other names: 497-9004

Application information
4.7
Note:
4.8
4.9
24/29
Shutdown time
When the standby command is set, the time required to put the two output stages into high
impedance and to put the internal circuitry in shutdown mode, is typically 5ms. This time is
used to decrease the gain and avoid any pop noise during shutdown.
The gain decreases smoothly until the outputs are muted (see
Consumption in shutdown mode
Between the shutdown pin and GND there is an internal 300kΩ resistor. This resistor forces
the TS2007 to be in shutdown when the shutdown input is left floating.
However, this resistor also introduces additional shutdown power consumption if the
shutdown pin voltage is not 0V.
Referring to
example, you must add 0.4V/300k=1.3µA in typical (0.4V/273k=1.46µA in maximum) to the
shutdown current specified in
Single-ended input configuration
It is possible to use the TS2007 in a single-ended input configuration. However, input
coupling capacitors are needed in this configuration. The following schematic diagram
shows a typical single-ended input application.
Figure 50. Typical application for single-ended input configuration
Input
Table 2: Operating conditions on page
Gain Select Control
Cin
Cin
Standby Control
4
3
Table 5
IN-
IN+
Standby
Control
Select
Gain
GS
Standby
to
Table
+
-
9.
Oscillator
PWM
VCC
Gnd
Vcc
3, with a 0.4V shutdown voltage pin for
Bridge
H
Cs
1uF
TS2007
OUT+
OUT-
Figure
8
5
49).
Speaker
TS2007