POEPHYTEREV-E National Semiconductor, POEPHYTEREV-E Datasheet - Page 52

• Manufacturer Part Number: POEPHYTEREV-E
• Description: BOARD EVAL LM5072, DP83848I
• Manufacturer: National Semiconductor
• Series: PHYTER®r

Specifications of POEPHYTEREV-E

• Main Purpose: Special Purpose DC/DC, Power Over Ethernet
• Outputs And Type: 1, Isolated
• Power - Output: 24W
• Voltage - Output: 3.3V
• Current - Output: 7.3A
• Voltage - Input: 39 ~ 57V
• Regulator Topology: Flyback
• Frequency - Switching: 250kHz
• Board Type: Fully Populated
• Utilized Ic / Part: DP83848, LM5072
• Lead Free Status / RoHS Status: Not applicable / Not applicable

www.national.com
7.2.2 MII Interrupt Control Register (MICR)
This register implements the MII Interrupt PHY Specific Control register. Sources for interrupt generation include: Energy
Detect State Change, Link State Change,
any of the counters becoming half-full. The individual interrupt events must be enabled by setting bits in the MII Inter-
rupt Status and Event Control Register (MISR)
15:3
Bit
2
1
0
Bit Name
Reserved
INT_OE
INTEN
TINT
Table 22. MII Interrupt Control Register (MICR), address 0x11
Default
0, RW
0, RW
0, RW
0, RO
Speed Status Change, Duplex Status Change, Auto-Negotiation Complete or
.
Reserved: Write ignored, Read as 0
Test Interrupt:
Forces the PHY to generate an interrupt to facilitate interrupt test-
ing. Interrupts will continue to be generated as long as this bit re-
mains set.
1 = Generate an interrupt
0 = Do not generate interrupt
Interrupt Enable:
Enable interrupt dependent on the event enables in the MISR reg-
ister.
1 = Enable event based interrupts
0 = Disable event based interrupts
Interrupt Output Enable:
Enable interrupt events to signal via the PWR_DOWN/INT pin by
configuring the PWR_DOWN/INT pin as an output.
1 = PWR_DOWN/INT is an Interrupt Output
0 = PWR_DOWN/INT is a Power Down Input
52
Description