EVALB1127-SUPPORT Fujitsu Semiconductor America Inc, EVALB1127-SUPPORT Datasheet - Page 18

• Manufacturer Part Number: EVALB1127-SUPPORT
• Description: KIT TUNING/DEV BOARD W/SUPPORT
• Manufacturer: Fujitsu Semiconductor America Inc

Specifications of EVALB1127-SUPPORT

• Sensor Type: Touch, Capacitive
• Interface: I²C
• Voltage - Supply: 2.3 V ~ 5.5 V
• Embedded: No
• Utilized Ic / Part: FMA1127
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Sensing Range: -
• Other names: 865-1052

Touch Sensor Controller
16
Typical Application
Notes:
• The voltage range of VDD can be from 2.3V to 5.5V. If internal LDO is used, it should be from 3V to 5.5V.
• Pull-Up resistors are required for I
• Each tuning capacitor is an optional component depending on PCB layout environment.
• The circuit above is a typical application circuit using an internal LDO.
• RESET_N pin should be connected to host MCU GPIO and needs an RC filter. (R1=10KΩ, C1=1uF)
• For LED control through DIO ports, sink current circuit is mandatory as shown above.
Fujitsu Microelectronics America, Inc.
resistor is typically used.
Touch PAD
Touch_Sensor_1 0
Touch_Sensor_9
Touch_Sensor_1
Touch_Sensor_0
Touch_Sensor_1 1
Touch_Sensor_7
Touch_Sensor_6
Touch_Sensor_4
Touch_Sensor_3
Touch_Sensor_2
Touch_Sensor_8
Touch_Sensor_5
2
C communication. For 5V application, 2K ohm resistor is typically used. For 3V application, 1K ohm
Touch PAD
Data Sensor
Tuning Cap
FMA1127DC
30S
From MCU
2K
2K
R1
10K
1uF
C1
RESET_N
(LED Control Circuit)
DIO_N
Reference Sensor
Tuning Cap
VDD