STEVAL-MKI085V1 STMicroelectronics, STEVAL-MKI085V1 Datasheet - Page 24
![BOARD ADAPTER LPY410AL DIL24](/photos/28/40/284017/steval-mki085v1_sml.jpg)
STEVAL-MKI085V1
Manufacturer Part Number
STEVAL-MKI085V1
Description
BOARD ADAPTER LPY410AL DIL24
Manufacturer
STMicroelectronics
Series
MEMSr
Datasheets
1.STEVAL-MKI009V1.pdf
(42 pages)
2.STEVAL-MKI085V1.pdf
(4 pages)
3.STEVAL-MKI085V1.pdf
(35 pages)
Specifications of STEVAL-MKI085V1
Sensor Type
Gyroscope, 2 Axis
Sensing Range
±100°/sec
Interface
Analog
Sensitivity
10mV/°/s
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
LPY410AL
Sensing Axis
Double Axis
Output Type
Analog, Digital
Interface Type
USB
Operating Voltage
5 V
For Use With
497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Supply
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
LPY410AL
Other names
497-10597
STEVAL-MKI0xxV1 Lite
6
24/35
STEVAL-MKI0xxV1 Lite
A lite version of the GUI together with its source code is also included in the installation
pack. The source code can be found in the directory: ($Home)\STM\STEVAL-
MKI0xxV1\STEVAL-MKI0xxV1_lite, where ($Home) is the directory in which the software
that came with the demonstration kit was installed (C:\Program Files by default).
The purpose of the lite version is to provide the user with a foundation for the development
of a customized application.
The lite version of the demonstration kit is started by launching the STEVAL-MKI0xxV1 Lite
executable file located in the STEVAL-MKI0xxV1 > Executables folder.
An example of the GUI of the STEVAL-MKI0xxV1 Lite application is shown in
Figure 17. STEVAL-MKI0xxV1 Lite GUI
Follow these instructions to use the software:
1.
2.
3.
4.
5.
6.
Connect the STEVAL-MKI0xxV1 to the USB port.
Launch the GUI for STEVAL-MKI0xxV1 Lite.
Select the virtual COM port and click on the “Connect” button.
Select the destination file to which the yaw rate data must be saved (optional).
Click on the “START” (or “STOP”) button to activate (or stop) the sensor data collection,
saving to file, and screen plotting functions.
To close the application, click on “Disconnect” and then click on “Exit”.
Doc ID 16617 Rev 1
Figure
UM0855
17.