STEVAL-MKI083V1 STMicroelectronics, STEVAL-MKI083V1 Datasheet - Page 9
![BOARD ADAPTER LPY4150AL DIL24](/photos/28/40/284019/steval-mki083v1_sml.jpg)
STEVAL-MKI083V1
Manufacturer Part Number
STEVAL-MKI083V1
Description
BOARD ADAPTER LPY4150AL DIL24
Manufacturer
STMicroelectronics
Series
MEMSr
Datasheets
1.STEVAL-MKI009V1.pdf
(42 pages)
2.STEVAL-MKI082V1.pdf
(4 pages)
3.STEVAL-MKI083V1.pdf
(35 pages)
Specifications of STEVAL-MKI083V1
Sensor Type
Gyroscope, 2 Axis
Sensing Range
±1500°/sec
Interface
Analog
Sensitivity
0.67mV/°/s
Voltage - Supply
5V, USB
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
LPY4150AL
Sensing Axis
Double Axis
Output Type
Analog, Digital
Interface Type
USB
Operating Voltage
5 V
For Use With
497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
LPY4150AL
Other names
497-10599
UM0701
5
5.1
5.1.1
Note:
System setup
The system consists of three boards: the STM32 demonstration board, the STM32-MEMS
demonstration board and the MEMS demonstration board. The set-up of the system can be
split into three main steps.
1.
2.
3.
4.
Steps 1 to 3 vary according to the type of STM32 demonstration board and MEMS
demonstration board used. They are described in the following chapters.
Regarding step 4: all MEMS demonstration boards compatible with the DIL24 socket can be
connected to the STM32-MEMS board. The correct orientation of the board is depicted in
Figure 4
Figure 4.
System setup with STM3210B-EVAL board
Connecting the STM32-MEMS board
Table 1.
The CN4 connector of the STM32-MEMS board is connected to the JP11 jumper of the
STM3210B-EVAL board in order to distribute V
JP16 jumper of the STM32-MEMS board takes over the V
JP11 jumper of the STM3210B-EVAL board.
Set-up of the STM32 demonstration board. In some cases, minor changes may have to
be made to the board.
Set-up of the jumpers on the STM32-MEMS board.
Connection of the STM32-MEMS board to the STM32 demonstration board.
Connection of the MEMS demonstration board to the STM32-MEMS board.
by the ST logo printed on the top side of the STM32-MEMS board.
Pin of STM32-MEMS board
Connecting MEMS demonstration board to STM32-MEMS board
Connecting the STM32-MEMS board to the STM3210B-EVAL board
CN1-1
CN2-1
CN4-1
Doc ID 15703 Rev 1
CC
to the MEMS sensor. In this setup, the
Connected to pin of STM3210B-EVAL
BAT
selection functionality of the
CN12-1
CN13-1
JP11-1
System setup
9/42