STEVAL-MKI095V1 STMicroelectronics, STEVAL-MKI095V1 Datasheet - Page 10
![BOARD ADAPTER LPR4150AL DIL24](/photos/28/40/284021/steval-mki095v1_sml.jpg)
STEVAL-MKI095V1
Manufacturer Part Number
STEVAL-MKI095V1
Description
BOARD ADAPTER LPR4150AL DIL24
Manufacturer
STMicroelectronics
Series
MEMSr
Datasheets
1.STEVAL-MKI009V1.pdf
(42 pages)
2.STEVAL-MKI099V1.pdf
(35 pages)
3.STEVAL-MKI095V1.pdf
(4 pages)
Specifications of STEVAL-MKI095V1
Sensor Type
Gyroscope, 2 Axis
Sensing Range
±1500°/sec
Interface
Analog
Sensitivity
0.67mV/°/s
Voltage - Supply
5V, USB
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
LPR4150AL
Interface Type
GUI, USB
For Use With
497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
LPR4150AL
Other names
497-10605
System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701