STEVAL-MKI006V1 STMicroelectronics, STEVAL-MKI006V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI006V1
• Description: BOARD EVALUATION LIS302DL
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI006V1

• Design Resources: STEVAL-MKI006V1 Gerber Files STEVAL-MKI006V1 Schematic STEVAL-MKI006V1 Bill of Materials
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2.3g, 9.2g
• Interface: SPI, USB
• Sensitivity: 18 ~ 72 mg/Digit
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LIS302DL
• Acceleration: 2 g, 8 g
• Sensing Axis: Triple Axis
• Output Type: Digital
• Interface Type: USB
• Silicon Manufacturer: ST Micro
• Silicon Core Number: LIS302DL
• Kit Application Type: Sensing - Motion / Vibration / Shock
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6229

System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701