STEVAL-MKI079V1 STMicroelectronics, STEVAL-MKI079V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI079V1
• Description: BOARD DEMO MEMS LPR430AL
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI079V1

• Design Resources: STEVAL-MKI079V1 Schematic STEVAL-MKI079V1 Bill of Materials STEVAL-MKI079V1 Gerber Files
• Sensor Type: Gyroscope, 2 Axis
• Sensing Range: ±300°/sec
• Interface: Analog and Digital
• Sensitivity: 3.33mV/°/s
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LPR430AL
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR4xxAL, LPR4xxxAL
• Other names: 497-10671

System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701