AS5030 DB austriamicrosystems, AS5030 DB Datasheet - Page 6

• Manufacturer Part Number: AS5030 DB
• Description: BOARD DEMO AS5030
• Manufacturer: austriamicrosystems

Specifications of AS5030 DB

• Sensor Type: Magnetic, Rotary Position
• Sensing Range: 360°
• Interface: USB
• Voltage - Supply: 5V USB or 7.5V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: AS5030
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Sensitivity: -

AS5030 8 bit high speed magnetic rotary encoder
Demoboard Operation Manual
3.1.4
An external AS5030 device can be wired to this connector. It allows the user to test his own board, and/or fuse the configuration
bits for the mass production.
sensor, on-board or external, can be selected at the same time with the CS and eCS signal.
sensor, on-board or external, can be selected at the same time with the CS and eCS signal.
4
When operating the demo board and software it is advisable to proceed as:
Before starting the demo software the demo board needs to be connected to the USB port of the PC.
After finishing the work with the demo board the software needs to be closed before disconnecting the demo board.
Revision 1.0, 29-May-08
•
•
•
•
•
•
•
•
•
1.
2.
•
1.
2.
Troubleshooting
J4 connector for external AS5030
Pin 1: ePROG.
Is the 8.5V source for fusing. The high voltage is switched only during the programming phase.
Pin 2: eCS
Is an independent CS signal provided by the microcontroller, only for the external sensor
Pin 3: eDIO
Is the same signal as DIO used for the on board sensor. Both are connected through the R14 resistor (0R). Only one
Pin 4: eDCLK
Is the same signal as DCLK used for the on board sensor. Both are connected through the R46 resistor (0R). Only one
Pin 5: 5V
Is the power supply of the external sensor
Pin 6: 3.3V
Not used
Pin 7: VSS
Pin 8: eVOUT
Analog input. Not used
Running the demo software
Connect to the USB port.
Start the software.
Closing the demo software
Close the software.
Disconnect from the USB port.
www.austriamicrosystems.com
Page 6 of 8