STEVAL-MKI088V1 STMicroelectronics, STEVAL-MKI088V1 Datasheet - Page 10
![BOARD DEMO FOR LIS33DE](/photos/9/19/91980/steval-mki088v1_sml.jpg)
STEVAL-MKI088V1
Manufacturer Part Number
STEVAL-MKI088V1
Description
BOARD DEMO FOR LIS33DE
Manufacturer
STMicroelectronics
Series
MEMS, nanor
Datasheets
1.STEVAL-MKI009V1.pdf
(42 pages)
2.STEVAL-MKI088V1.pdf
(31 pages)
3.STEVAL-MKI088V1.pdf
(4 pages)
Specifications of STEVAL-MKI088V1
Sensor Type
Accelerometer, 3 Axis
Sensing Range
±2.3g, 9.2g
Interface
I²C, SPI
Sensitivity
18mg/digit, 72mg/digit
Embedded
No
Utilized Ic / Part
LIS33DE
Acceleration
2.3 g, 9.2 g
Sensing Axis
Triple Axis
Interface Type
I2C, SPI
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Supply
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
LIS33DE
Other names
497-10522
System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701