STEVAL-MKI091V1 STMicroelectronics, STEVAL-MKI091V1 Datasheet - Page 10
![DEMO BOARD FOR LIS331DLM](/photos/9/19/91981/steval-mki091v1_sml.jpg)
STEVAL-MKI091V1
Manufacturer Part Number
STEVAL-MKI091V1
Description
DEMO BOARD FOR LIS331DLM
Manufacturer
STMicroelectronics
Series
MEMS, nanor
Datasheets
1.STEVAL-MKI009V1.pdf
(42 pages)
2.STEVAL-MKI091V1.pdf
(38 pages)
3.STEVAL-MKI091V1.pdf
(4 pages)
Specifications of STEVAL-MKI091V1
Sensor Type
Accelerometer, 3 Axis
Sensing Range
±2g, 4g, 8g
Interface
I²C, SPI
Sensitivity
64LSB/G, 32LSB/g, 16LSB/g
Embedded
No
Utilized Ic / Part
LIS331DLM
Acceleration
2 g, 4 g, 8 g
Sensing Axis
Triple Axis
Interface Type
I2C, SPI
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Supply
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
LIS331DLM
Other names
497-10491
System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701