SK-16FX-EUROSCOPE-FMA Fujitsu Semiconductor America Inc, SK-16FX-EUROSCOPE-FMA Datasheet - Page 9

• Manufacturer Part Number: SK-16FX-EUROSCOPE-FMA
• Description: KIT BUNDLE 100PMC KIT/SOFTWARE
• Manufacturer: Fujitsu Semiconductor America Inc
• Series: F²MC-16FXr
• Type: MCUr

Specifications of SK-16FX-EUROSCOPE-FMA

• Contents: Board, Cables, CD
• For Use With/related Products: MB96340
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 865-1100

Fujitsu Microelectronics America Inc
The Hardware
S1: Mode selection
PROG:
RUN:
JP3: DTR-Reset
Set the jumper to 1-2 to connect
the DTR-Signal
of the UART connector to the
microcontroller reset-pin.
Set the jumper to 2-3 to connect
the DTR-Signal
of the USB connector to the
microcontroller reset-pin.
Some terminal-programs, e.g.
Fujitsu‘s Skwizard, allow to reset
the evaluation board by using the
DTR-Signal.
JP6: MD0 selection
Close this jumper to control the
MD0 level by the RTS signal of the
USB interface
The jumpers
Select the run-mode
Select the program-mode
JP4: UART RX select
R-0: UART0=UART‘A‘ / U-1: UART1=UART‘B‘ (USB)
R-1: UART1=UART‘A‘ / U-0: UART0=UART‘B‘ (USB)
JP9: MCU Vcc
This jumper can be used to measure
the current consumption of the MCU
JP10: 5V / 3.3V
1-2: 5V supply is used
2-3: 3.3V supply is used
JP5: UART TX select
R-0: UART0=UART‘A‘ / U-1: UART1=UART‘B‘ (USB)
R-1: UART1=UART‘A‘ / U-0: UART0=UART‘B‘ (USB)
All Rights Reserved.© Fujitsu Limited 2007
JP11: Power Supply
1-2: USB supply is used
2-3: External supply is used
9