C8051F996-TB Silicon Laboratories Inc, C8051F996-TB Datasheet - Page 15
![DEV KIT FOR C8051F999/F998](/photos/28/93/289371/c8051f996tb_sml.jpg)
C8051F996-TB
Manufacturer Part Number
C8051F996-TB
Description
DEV KIT FOR C8051F999/F998
Manufacturer
Silicon Laboratories Inc
Type
MCUr
Datasheet
1.C8051F996-TB.pdf
(24 pages)
Specifications of C8051F996-TB
Contents
Board
Processor Series
C8051F9x
Data Bus Width
8 bit
Interface Type
USB, UART
Core
8051
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
C8051F98, C8051F99
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
336-1986
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
C8051F996-TB
Manufacturer:
Silicon Laboratories Inc
Quantity:
135
C8051F996-DK
7.3. System Clock Sources
7.3.1. Internal Oscillators
The C8051F996 device installed on the target board features a factory calibrated programmable high-frequency
internal oscillator (24.5 MHz base frequency, ±2%) and a low power internal oscillator (20 MHz ±10%). After each
reset, the low power oscillator divided by 8 results in a default system clock frequency of 2.5 MHz (±10%). The
selected system clock and the system clock divider may be configured by software for operation at other
frequencies. For low-frequency operation, the C8051F996 features a smaRTClock real time clock. A 32.768 kHz
Watch crystal (Y2) is included on the target board. If you wish to operate the C8051F996 device at a frequency not
available with the internal oscillators, an external crystal may be used. Refer to the C8051F99x-C8051F98x data
sheet for more information on configuring the system clock source.
7.3.2. External Oscillator Options
The target board is designed to facilitate the installation of an external crystal (Y1). Install a 10 M resistor at R17
and install capacitors at C20 and C21 using values appropriate for the crystal you select. If you wish to operate the
external oscillator in capacitor or RC mode, options to install a capacitor or an RC network are also available on the
target board. Populate C21 for capacitor mode, and populate R16 and C21 for RC mode. Refer to the C8051F99x-
C8051F98x data sheet for more information on the use of external oscillators.
7.4. Port I/O Headers (J2, J3, J18, J6)
Access to all Port I/O on the C8051F996 is provided through the headers J2, J3, and J18. The header J6 provides
access to the ground plane for easy clipping of oscilloscope probes.
Rev. 0.1
15