M5211DEMO Freescale Semiconductor, M5211DEMO Datasheet - Page 6

• Manufacturer Part Number: M5211DEMO
• Description: KIT DEMO FOR MCF5211
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MPUr

Specifications of M5211DEMO

• Contents: SBC, Cables and Software
• Processor To Be Evaluated: MCF521x
• Data Bus Width: 12 bit
• Interface Type: RS-232, USB
• Operating Supply Voltage: 9 V
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire
• Core Sub-architecture: Coldfire V2
• Silicon Core Number: MCF52
• Silicon Family Name: MCF521x
• Rohs Compliant: Yes
• For Use With/related Products: MCF5211, MCF5212, MCF5213
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Memory Map
Connect the USB cable to an open USB port on the host PC and attach to the USB port on the target board.
LED's 1–4 located adjacent to the DB-9 connector, and the VDD LED will light and the loaded application
will begin to execute.
4.2
DEBUG mode supports application development and debug using the ColdFire background debug mode
(BDM). Background mode is accessible using either the integrated USB-BDM or an external ColdFire
BDM cable. Use of the integrated BDM requires a host PC with an available USB port and an A/B USB
cable and appropriate hosting software. The USB cable used must be USB 2.0 compliant. A 26-pin
BDM_PORT header supports the use of an external BDM cable. This header is not installed in default
configurations. The steps describe using the integrated USB-BDM. See
on configuring the board for alternate power input.
Connect the supplied USB cable between an available USB port on the host PC and the USB connector on
the board.
Hosting development software will establish background communication.
5
Refer to the MCF5213 Integrated Microcontroller Reference Manual for details.
6
1. Connect a serial cable between the board and a host PC if needed.
2. Connect auxiliary equipment to board if needed.
3. Install and launch CodeWarrior™ 6.1 Special Edition, or other software capable of communicating
4. Configure the board option jumpers as shown in
with the ColdFire MCU.
DEBUG Mode
Memory Map
Demonstration Board for Freescale MCF5211, Rev. 1
PWR_SEL
BDM_EN
COM_EN
VX_EN
PWR_SEL
BDM_EN
COM_EN
VX_EN
Table 3. Debug Mode Setup
Table 2. Run Mode Setup
Set to VB
OFF
ALL ON (if required)
ON (if required)
Set to VB
ON
ALL ON (if required)
ON (if required)
Table
3.
Section 7,
“Power,” for details
Freescale Semiconductor