M68EVB908QL4 Freescale Semiconductor, M68EVB908QL4 Datasheet - Page 3
![BOARD EVALUATION FOR 908QL4 MCU](/photos/9/23/92356/m68evb908ql4_sml.jpg)
M68EVB908QL4
Manufacturer Part Number
M68EVB908QL4
Description
BOARD EVALUATION FOR 908QL4 MCU
Manufacturer
Freescale Semiconductor
Type
MCUr
Datasheet
1.M68EVB908QL4.pdf
(13 pages)
Specifications of M68EVB908QL4
Contents
Module and Misc Hardware
For Use With/related Products
MC68HC908QL4 Family
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
M 6 8 E V B 9 0 8 Q L 4
Cautionary Notes
1) Electrostatic Discharge (ESD) prevention measures should be applied whenever handling
2) Axiom Manufacturing reserves the right to make changes without further notice to any
products to improve reliability, function or design. Axiom Manufacturing does not assume any
liability arising out of the application or use of any product or circuit described herein; neither
does it convey any license under patent rights or the rights of others.
3) EMC Information on the M68EVB908QL4 board:
Terminology
This development board applies option selection jumpers. Terminology for application of the
option jumpers is as follows:
This development board applies hard wired option selections (JP2). These option selections
apply a circuit trace between the option pads to complete a default connection. This type
connection places an equivalent Jumper Installed type option. The circuit trace between the
option pads maybe cut with a razor blade or similar type knife to isolate the default connection
provided. Applying the default connection again can be performed by installing the option post
pins and shunt jumper, or by applying a wire between the option pads.
a) This product as shipped from the factory with associated power supplies and cables, has
b) This product is designed and intended for use as a development platform for hardware
c) In a domestic environment this product may cause radio interference in which case the
d) Attaching additional wiring to this product or modifying the products operation from the
this product. ESD damage is not a warranty repair item.
been tested and meets with requirements of CE and the FCC as a CLASS A product.
or software in an educational or professional laboratory.
user may be required to take adequate prevention measures.
factory default as shipped may effect its performance and also cause interference with
other apparatus in the immediate vicinity.
mitigating measures should be taken.
Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and the
shunt is installed so that the 2 pins are connected with the shunt.
Jumper off, out, or idle = jumper or shunt is installed so that only 1 pin holds the shunt,
no 2 pins are connected, or jumper is removed. It is recommended that the jumpers be
idled by installing on 1 pin so they will not be lost.
3
If such interference is detected, suitable
1 2 / 0 4 / 0 3