R0K33026AS000BE Renesas Electronics America, R0K33026AS000BE Datasheet - Page 17
![KIT DEV EVALUATION M16C/26A](/photos/9/23/92366/r0k33026as000be_sml.jpg)
R0K33026AS000BE
Manufacturer Part Number
R0K33026AS000BE
Description
KIT DEV EVALUATION M16C/26A
Manufacturer
Renesas Electronics America
Series
Renesas Starter Kits (RSK)r
Type
MCUr
Datasheets
1.R0K33026AS000BE.pdf
(28 pages)
2.R0K33026AS000BE.pdf
(23 pages)
3.R0K33026AS000BE.pdf
(7 pages)
Specifications of R0K33026AS000BE
Contents
CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
For Use With/related Products
M16C/26A
Lead Free Status / RoHS Status
Not applicable / Not applicable
6.7.Oscillator Sources
A crystal oscillator or ceramic resonator is fitted on the Renesas Starter Kit and used to supply the main clock input to the Renesas
microcontroller. A crystal oscillator is fitted on the Renesas Starter Kit and used to supply the sub clock input.
Table 6-11: Oscillators / Resonators details the oscillators that are fitted and alternative footprints provided on this Renesas Starter Kit:
6.8.Reset Circuit
The CPU Board includes a simple latch circuit that links the mode selection and reset circuit. This provides an easy method for swapping
the device between Boot mode and Single chip mode. This circuit is not required on customers’ boards as it is intended for providing
easy evaluation of the operating modes of the device on the Renesas Starter Kit. Please refer to the hardware manual for more
information on the requirements of the reset circuit.
The Reset circuit operates by latching the state of the boot switch on pressing the reset button. This control is subsequently used to
modify the mode pin states as required.
The mode pins should change state only while the reset signal is active to avoid possible device damage.
The reset is held in the active state for a fixed period by a pair of resistors and a capacitor. Please check the reset requirements carefully
to ensure the reset circuit on the user’s board meets all the reset timing requirements.
Component
Main clock (X1)
Main clock (X2)
Sub clock (X3)
Fitted
Not Fitted
Fitted
Table 6-11: Oscillators / Resonators
10 MHz (HC/49U package)
10 MHz (e.g. Murata CSTCE10M0G55)
32.768kHz (90SMX package)
13