761135 Spectrum Digital Inc, 761135 Datasheet - Page 37

CODE COMPOSR STUDIO EZDSP F28335

761135

Manufacturer Part Number
761135
Description
CODE COMPOSR STUDIO EZDSP F28335
Manufacturer
Spectrum Digital Inc
Type
DSPr
Datasheet

Specifications of 761135

Contents
Board, Cable, CD, Power Supply
Positions/sockets
1
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
TMS320F28335
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
2.4.7 JP8, CANB Termination Resistor Select
2.5 LEDs
Jumper JP8 is used to select the termination resistor on the CANB interface. When
installed a termination resistor is placed between pins 3 and 4 of the connector J11.
This jumper is installed at the factory. The positions are shown in the table below.
The layout of this jumper is shown in the figure below.
The eZdsp
+5 volts and is normally ‘on’ when power is applied to the board. LED DS2 is under
control of the GPIO32 line from the processor. DS201 is connected to the embedded
USB emulator and shows the status of the emulation link. These are shown in the table
below.
Configuration
Installed/shorted
Table 23: JP8, CANB Termination Resistor Select
TM
LED #
DS201
DS1
DS2
Open
F28335 has three light-emitting diodes. DS1 indicates the presence of
Installed/shorted
Color
Green
Green
Green
Termination resistor NOT resistor installed
JP8
Figure 2-21, Jumper JP8
Table 24: LEDs
Embedded emulation link status
Termination resistor installed
Controlling Signal
Function
GPIO32
+5 Volts
Open
JP8
Spectrum Digital, Inc
2-23

Related parts for 761135