101-0679 Rabbit Semiconductor, 101-0679 Datasheet - Page 14

• Manufacturer Part Number: 101-0679
• Description: KIT DEV RABBIT RCM3600 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-0679

• Contents: RabbitCore Module, Dev. Board, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: RS-232
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 5 V
• For Use With/related Products: RCM3600
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.2 Hardware Connections
There are three steps to prepare the RCM3600 for use with Dynamic C and the sample
programs:
1. Attach the RCM3600 module to the Prototyping Board.
2. Connect the programming cable between the RCM3600 and the COM port on the
3. Connect the power supply to the Prototyping Board.
2.2.1 Attach Module to Prototyping Board
Turn the RCM3600 module so that the Rabbit 3000 chip is facing up as shown in Figure 2
below. Insert the pins from the module’s J1 header on the bottom side of the RCM3600
into the TCM_SMT_SOCKET socket on the Prototyping Board. The shaded corner notch
at the bottom right corner of the RCM3600 module should face the same direction as the
corresponding notch below it on the Prototyping Board.
Press the module’s pins firmly into the Prototyping Board headers.
8
workstation PC.
NOTE: It is important that you line up the pins on header J1 of the RCM3600 module
exactly with the corresponding pins of the TCM_SMT_SOCKET socket on the Proto-
typing Board. The header pins may become bent or damaged if the pin alignment is off-
set, and the module will not work. Permanent electrical damage to the module may also
result if a misaligned module is powered up.
Figure 2. Install the RCM3600 Series on the Prototyping Board
RabbitCore RCM3600