EDK3687 Renesas Electronics America, EDK3687 Datasheet - Page 4

• Manufacturer Part Number: EDK3687
• Description: DEV EVALUATION KIT H8/3687
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of EDK3687

• Contents: 2G (Second-generation) Evaluation Board, HEW debugger support, Cable and CD-ROM
• For Use With/related Products: H8/3687
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

EDK3687 Quickstart Guide
The following procedure explains how to connect to the EDK and debug the project in HEW.
Disconnect power from the board.
Please refer to section 5 in the EDK User Manual for more information.
The EDK uses HMON to connect to HEW and debugging is carried out in User Programming Mode. If for any reason the
user mode programming fails (due to user code activating a timer for example) then the BOOT mode programming sequence
in section 3 will need to be used.
To run the program:
Congratulations! You have installed the software; programmed the EDK and run your first program with the debugger. To
continue learning about the tools and the board please read the EDK Tutorial Manual and supporting User Manuals
Technical Support
The EDK is a tool for evaluation purposes only. Technical support is limited to that which is provided on the Renesas
Technology Europe website at:
Renesas Technology Europe Ltd.
4
•
•
•
•
•
•
•
•
•
•
•
The Program Counter will go to the program start address, denoted by a yellow arrow.
•
•
Running the Debugger
CJ4 (User Configuration)
R e-apply power to the EDK.
Click on the HMON FLASH Download Setting button.
Click on the USER radio button.
Ensure that the “uKernel Address” is set to H’0400, and that the “Referenced Value” box is not checked. Ensure
that the “Return Address” is set to H’0, and that the “Referenced Value” box is checked, and click “OK”
Click “Save Session”, from the “File” menu.
Click “Build”, “Debug”, “Connect”.
The console window will report that the EDK has connected.
Right click on the “.abs” file in the “Download Module” section, and choose “Download Module”.
Double-click on the resetprg.c file in the HEW Project workspace window, under the “C Source File” folder.
The C code listing will appear with a margin at the left showing the areas in memory where the code has been
loaded.
Click on the “ResetCPU” button,
Select the "Debug", "Reset Go" menu item.
Both the User LEDs on the EDK will start flashing,
http://www.eu.renesas.com/tools
PIN CONNECTIONS
1 – 2
.
4 – 5
8 – 9
10 – 11
D - Type
9 - Way
Switch
Reset
CJ4
D004176_11_v03
4