EDK2612 Renesas Electronics America, EDK2612 Datasheet - Page 4

• Manufacturer Part Number: EDK2612
• Description: DEV EVALUATION KIT H8S/2612
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of EDK2612

• Contents: 2G (Second-generation) Evaluation Board, HEW debugger support, Cable and CD-ROM
• For Use With/related Products: H8S/2612
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The following procedure explains how to load the file you built in Section 2, into the EDK to debug using the HDI debugger.
To set up a link between the HDI-Debugger and the EDK you first need to:
To run the program:
Congratulations! You have installed the software; programmed the EDK and run your first program with the debugger. To
continue learning about the tools and the board please read the EDK User Manual and the Tutorial Manual.
Technical Support
The EDK is a tool for evaluation purposes only. Technical support is limited to that which is provided on the Hitachi Micro
Systems website at:
Hitachi Micro Systems
Running the Debugger
•
•
•
•
•
•
•
•
•
•
•
Ensure that the EDK is connected to Serial port “COM1” on the PC.
Start HDI by using the Start Menu to navigate to and select "Hitachi Debugging Interface\EDK Monitor".
In the "Select Session" dialog box, select "Create a new session on:" and set the correct debugging platform for the
EDK2612 of H8S/2600 Monitor. Click "OK".
If prompted for the communication settings, the required baud rate is 115200.
A successful link between the HDI debugger and the EDK will be indicated with a "Link Up" message in the Status
Bar (found in the bottom left hand corner of the HDI window).
Select the "File", "Load Program…"
Load the debug file EDK2612_debug.abs, from the project's Debug directory. If you use the Browse button, please
ensure that the "File of types" drop list is set to (*.abs) as the file extension.
Depending on your Confirmation options, a message box may appear providing details of memory areas used by the
program. Select "OK". (This information can also be seen in the Status view's "Memory" pane.)
Select the "View", "Source" menu item and navigate to the source file main.c
Select the "Run", "Reset Go" menu item.
The USR2 LED on the EDK will start flashing,
http://www.hmse.com/products/edk/support/index.htm
menu item to open the "Load Program" dialog box.
Hitachi Micro Systems
D004317_11_v02
4