DEMOKIT-KA1 Renesas Electronics America, DEMOKIT-KA1 Datasheet - Page 41

• Manufacturer Part Number: DEMOKIT-KA1
• Description: KIT DEMO 78K0S KA1 UPD78F9222
• Manufacturer: Renesas Electronics America

Specifications of DEMOKIT-KA1

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DemoKit-KA1 User’s Manual
The Operation Mode box enables you to divide the flash memory of some target devices into
blocks or areas. Some devices do not have the block and area division modes, and some have
only one mode. In these cases, modes that don’t exist cannot be selected.
• Choosing Chip subjects the entire flash memory area of the target device to rewrite
• Choosing Block requires you to specify range using the Start and End lists. The block of
• Selecting Area requires you to specify a range using the Start and End lists. The specified
• Selecting Show Address displays the addresses in the Start and End lists. If this check box
The Advance setup tab is used to specify the command options and security flag settings.
When "Advance" is clicked, the following window is displayed:
locked loop (PLL) circuit, enter a division rate or multiplication rate according to the use
environment. Division and multiplication rates differ depending on the device, so be sure to
check the specifications of the device used before choosing a rate. If the target device does
not have an on-chip PLL circuit, select "1.0". On the initial screen, the default setting is
displayed according to the parameter file.
processing.
flash memory specified is then subject to reconfiguration.
area of flash memory is then subject to reconfiguration.
is not checked, numbers are displayed.
Figure 41. Supply Oscillator Box
Figure 42. Operation Mode
35