100-3040 Bluetechnix, 100-3040 Datasheet - Page 24

• Manufacturer Part Number: 100-3040
• Description: KIT BLACKFIN STARTER CM-BF538
• Manufacturer: Bluetechnix
• Type: DSPr

Specifications of 100-3040

• Contents: Board, Module, Power Supply
• For Use With/related Products: ADSP-BF548 Blackfin® Processor
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

1000
1001
1010
1011
1100
1101
1110
1111
7 Installation
7.1 Initial Board Setup
The installation guide is written for Windows (Windows 2000 and WinXP). However for connecting the
USB device the driver for MAC and LINUX are available on the CD.
In order to set up und test your DEV-BF548-Lite board the following steps can be done:
Blackfin DEV-BF548-Lite. DEV-BF548DA-lite Hardware User Manual
1.
2.
3.
4.
Make sure jumpers JP2 and JP3 are set and the Switch S3 is in Position 1. as shown in Figure 7-1
(JP1 unset).
If you want to use an SD-Card, insert the SD-Card in the appropriate slot at the bottom side of
the board.
Connect the power supply to the power connector off the DEV-BF548-Lite board.
Connect the DEV-BF548-Lite Board via USB to the PC. The pre-flashed BLACKSheep starts and
the LED mounted on the DEV-BF548-Lite board starts blinking. On the PC usually the ‘Found
New Hardware Wizard’ opens.
Figure 7-1: Setup of the DEV-BF548-Lite Board
Reserved
Reserved
Boot from (DDR) SDRAM
Boot from OTP memory
Reserved
Boot from 8‐ or 16‐bit NAND flash memory via NFC
Boot from 16‐Bit Host DMA
Boot from 8‐Bit Host DMA
Table 6-1: Boot modes
23