HS0005KCU01H Renesas Electronics America, HS0005KCU01H Datasheet - Page 11

• Manufacturer Part Number: HS0005KCU01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU01H

• Contents: E10T-USB, Cable and CD-ROM
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A, SH3, SH4, SH4A & SH-Mobile
• Lead Free Status / RoHS Status: Not Compliant, Contains lead / RoHS non-compliant

1.2
Before connecting an E10A-USB emulator (hereafter referred to as the emulator) with the user
system, a connector must be installed in the user system so that a user system interface cable can
be connected. When designing the user system, refer to an example of recommended connection
between the connector and the MCU shown in this manual.
Before designing the user system, be sure to read the E10A-USB emulator user’s manual and the
hardware manual for related MCUs.
Connect pins 8, 9, 10, 12, 13, and 14 of the user system connector to GND firmly on the PCB.
These pins are used as electrical GND and to monitor the connection of the user system
connector. Note the pin arrangement of the user system connector.
Notes:1.
GND line
2.
User system GND
connection
Figure 1.1 Connecting the User System Interface Cable to the User System
Connecting the E10A-USB Emulator with the User System
The pin number assignments of the 14-pin connector differ from those of the E8a
emulator; however, the physical location is the same.
When designing the connector layout on the user board, do not place any components
within 3 mm of the connector.
User system interface cable
Pin 8
Section 1 Connecting the Emulator with the User System
Pin 1
Rev. 3.00 Jul. 31, 2009 Page 3 of 16
User system connector
User system
Tab
REJ10J1805-0300