ST7MDT2-DVP2/US STMicroelectronics, ST7MDT2-DVP2/US Datasheet - Page 50

• Manufacturer Part Number: ST7MDT2-DVP2/US
• Description: KIT DEVELOPMENT ST7
• Manufacturer: STMicroelectronics
• Series: ST7-DVP2r
• Type: Microcontrollerr

Specifications of ST7MDT2-DVP2/US

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72254, ST72215, ST72216, ST72104, ST72225, ST72213, ST72212, ST72101
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5 - Hardware Features
5.5
50/82
Jumper and solder point descriptions
The following table lists jumpers and solder points located on the development kit
board, and whether they can be configured by the user, and if so, what they do.
ISP-SEL
(TP17)
ISP DRV PRG
(TP4)
JAM PROG
(TP5)
CAN_SEL
(TP42)
5V_CAN
(TP43)
G1
G2
Jumper name
NO
Under
specific
circumstances.
NO
YES
YES
YES
YES
configurable?
User-
very
Use of this jumper could permanently damage the
development board. This jumper has been removed
from current versions of the ST7MDT2-DVP2.
On older ST7MDT2-DVP2 development kit boards,
you may need to use this jumper to perform an ISP
driver firmware patch as detailed in the application
note AN1363/0401, entitled Workaround to ISP Mode
Limitation in ST7MDT1-DVP2 and ST7MDT2-DVP2 .
DO NOT attempt to use this jumper for ISP mode
programming!
Use of this jumper is only supported following the
detailed instructions given in AN1363/0401, available
from ST’s website at http://mcu.st.com.
In currently released version of the development kit,
this jumper has been removed, as the ISP mode
limitation has been corrected.
Use of this jumper could permanently damage the
development board. This jumper has been removed
from current versions of the ST7MDT2-DVP2.
Enable this jumper when you wish to connect a CAN
demo board or any other CAN device to the DVP
board. Refer to
page 51.
Enable this jumper ONLY if you wish to allow the CAN
demo board’s 5 V CAN supply to be available to the
DVP board. Refer to
page 51.
Soldering the two poles of this solder point together
allows you to connect the clock to the OSC_OUT pin
on the passive probe connector (see
Clock
Soldering the two poles of this solder point together
allows you to power your application board using the
VDD pin in the passive probe connector (see
5.4.1
on page 49)
on page 63).
Description of utility
Section 5.6: CAN features
Section 5.6: CAN features
ST7MDT2-DVP2 User Manual
Section 5.10
Section
on
on
: