ST7MDT10-DVP3 STMicroelectronics, ST7MDT10-DVP3 Datasheet - Page 27

• Manufacturer Part Number: ST7MDT10-DVP3
• Description: EMULATOR REAL TIME ST7
• Manufacturer: STMicroelectronics
• Type: Emulatorr

Specifications of ST7MDT10-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST7 Flash MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7-DVP3 Emulator User Manual
5.3
In this case, your application clock source provides the clock signal for initiating
communication with your ST7 and ICCOSC is not connected to your ST7.
VDD_APPLI pin
This pin is not connected. It is only used with tools that have a power supply
follower.
ICC cable
Your ST7-DVP3 emulator includes an ICC cable for connecting to the ICC
connector on your application board. The provided cable is 30cm long, however
you can use a cable up to 2 meters long. Typical characteristics for provided ICC
cable are shown in
Changing configurations
Your ST7-DVP3 emulator is designed to connect to your application board either in
place of your ST7 via the probe (TEB, flat cables, adapters and socket), or the ICC
connection which is relayed to the ST7 on your application board. For more
information about the probe connection, refer to your ST7xxxx-DVP3 Probe User
Guide .
When using your emulator you must only use one connection at a time. If you
switch from one connection to another, follow the procedure outlined below.
Switching from ICC connection to the probe connection
1 Switch off the application board.
2 Disconnect the power to the ST7-DVP3 emulator.
3 Unplug the ICC cable from the HE10 connector on your application board.
4 Remove the MCU from its socket on the application board.
5 Connect the probe to your application board in place of your target MCU.
Table 4: Typical ICC cable characteristics
Table 4
, below.
Pitch
Section
Impedance
Nominal Voltage
Max. Current
Temperature
In-circuit Communication Configuration
1.27 mm
0.09mm2
100 Ohms
300V
1A
-10°C to +105° C
27/44