FS-9062 Digi International, FS-9062 Datasheet - Page 19

• Manufacturer Part Number: FS-9062
• Description: JTAG_BOOSTER FOR ANALOG DEVICES
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9062

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ADI, ADSP-BF531, 532, 533, 561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

•
•
•
•
•
•
•
JTAG_ADSP-BLACKFINa.doc
Target no longer connected
There is a cyclic check of the JTAG chain. Check target power. Check target
connection.
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no Analog Devices Blackfin in the JTAG chain
No Analog Devices Blackfin was found in the JTAG chain. Check the target
power. Try with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
Wrong Flash Identifier (xxxx)
No valid identifier found. Check the specified chip select signal and the bus
width. Try with the option /DEVICE= . Use the option /8BIT or /16BIT or
/32BIT to specify the correct data bus size.
Wrong length of boundary scan register. Should be 197 for a Analog
Devices ADSP-BF531/BF532/BF533. (Should be 355 for a Analog
Devices ADSP-BF561.)
The length of the boundary scan register of the selected part (if there are
more than one in the chain) does not fit to the Analog Devices Blackfin.
Check the target connection. Check the target CPU type. Check the settings
for /IROFFS= and /CPUPOS= , if there are several parts in the JTAG
chain.
JTAG-Booster for Analog Devices Blackfin
19