SCA3000-D02 PWB VTI Technologies, SCA3000-D02 PWB Datasheet - Page 16

• Manufacturer Part Number: SCA3000-D02 PWB
• Description: BOARD PWB W/SCA3000-D02
• Manufacturer: VTI Technologies
• Series: 180r

Specifications of SCA3000-D02 PWB

• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g
• Interface: I²C
• Sensitivity: 1333 counts/g
• Voltage - Supply: 2.35 V ~ 3.6 V
• Embedded: No
• Utilized Ic / Part: SCA3000-D02
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 551-1036

3.2 Non-volatile memory
3.3 Output Registers
VTI Technologies Oy
www.vti.fi
Add. is the register address in hex format.
RW – Read / Write register, R – Read-only register, NV – Register mirrors NV-memory data (NV = non-volatile).
IA – indirect addressing used.
Registers whose read and write access is blocked by register lock is marked in "Locked" column.
The SCA3000 has an internal non-volatile memory for calibration and configuration data. Memory
content will be programmed during production and is not user configurable. Initial configuration
values can be found in the following section 3.4.
The SCA3000 output registers (marked with 'Output' in Table 5) contents and bit definitions are
described in this section. Output registers contain information of measured acceleration and
temperature as well as information of the operating state and interrupts of SCA3000.
When reading the output values an MSB register must be read first because MSB register reading
latches the data in to all other acceleration output registers
Address: 04h
Register name: X_LSB, X-axis LSB frame
Address: 05h
Register name: X_MSB, X-axis MSB frame
Address: 06h
Register name: Y_LSB, Y-axis LSB frame
23h ... 3Fh
Bits
Bits
Bits
7:0
7:0
7:0
Addr.
21h
22h
Mode
Mode
Mode
R
R
R
Name
INT_MASK
CTRL_DATA
Value
Value
Value
Initial
Initial
Initial
00h
00h
00h
Doc.Nr. 8257300A.07
DATA
DATA
DATA
Description
HW interrupt mask register
(configures the operation of
INT-pin):
Data to/from register which
address is in CTRL_SEL
(18h) register
Reserved
Name
Name
Name
- interrupt when output
- interrupt when output
- mask all interrupts on
- INT-pin activity (INT
buffer is ¾ full
(enable / disable)
buffer is ½ full
(enable / disable)
INT-pin (enable / disable)
active low / INT active
high)
Description
X-axis LSB frame
Description
X-axis MSB frame
Description
Y-axis LSB frame
(R, W, RW, IA)
RW, NV, IA
RW, NV
Mode
Reg.
type
Conf
Conf
SCA3000 Series
Locked
x
-
Rev.A.07
16/ 43