M68ICS05C Freescale Semiconductor, M68ICS05C Datasheet - Page 16

• Manufacturer Part Number: M68ICS05C
• Description: SIM PROGRAM FOR 68HC705C8A/C9A
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS05C

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC705C8A/C9A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

INTRODUCTION
1.7 QUICK START INSTRUCTIONS
The following instructions summarize the hardware and software installation instructions of
Chapters 2 and 3.
If you are experienced in installing Motorola or other development tools, follow these steps.
1-4
Install the ICS05CW software: follow the instructions on the diskette label to run
the ICS05CW Setup program. During installation, follow the instructions in the
installation wizard: choose the Typical Install option to install the files to your hard
disk, or choose the Compact Install option to copy the files onto another diskette.
Connect the M68ICS05C pod: connect the M68ICS05C pod to the host PC’s serial
port using the included cable. Plug the cable into the pod connector P2.
Supply power to the M68ICS05C pod: connect the wall-mounted transformer’s
circular connector to the connector on the left side of the pod, next to the serial
connector.
Start the WinIDE editor and open the project files: Double click the WinIDE icon.
From the WinIDE Environment menu, choose the Open Project option, and choose a
project file from the Specify project file to open dialog. If no project file exists,
choose the New option from the File menu to create a new project file. Paragraph 8.3
gives additional information about setting up a sample project.
Configure the environment for the ICS05CW software components: from the
WinIDE Environment menu, select the Setup Environment option to open the
Environment Settings dialog and make the following changes:
The procedural instructions in this user’s manual assume that you
are familiar with the Windows interface and selection procedures.
Figures in this manual show ICS05CW windows and dialog boxes
as they appear in the Windows 95 environment.
Click on the EXE1 Debugger tab to bring the tab (Figure 1-1) to the front. Set
the executable type, path and filename, command line options (including
optional switches, filenames, or port settings), and other options for the
ICS05CW debugger application.
NOTE
M68ICS05COM/D