M68ICS08MR Freescale Semiconductor, M68ICS08MR Datasheet - Page 22

• Manufacturer Part Number: M68ICS08MR
• Description: SIM PROGRAM FOR 68HC908MR8/MR32
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08MR

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908MR8/MR32
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Preparation and Installation
2.2.2.3 I/O Baud Rate Selection Jumper (W3) — MR16/32 Only
2.2.2.4 Serial Communication Selection Jumper (W4)
User’s Manual
22
There are two sockets for clocks on the MRICS board, XY1 and XY2. Socket
XY1 is wired to drive the MR16/32 IC sockets and target connectors, and the
the clock is available for output on J10. Using the 4.9152-MHz clock as Y1
times the MR16/32 to communicate at 4800 or 9600 baud.
Use jumper W3 (Figure 2-3) to define the baud rate of the MR16/32. Install the
jumper in jumper position 1-2 (labeled 9600 baud) to communicate at 9600
baud if a 4.9152-MHz clock is installed as Y1. Place the jumper in the 2-3
position (labeled 4800 baud) to communicate at 4800 baud. If Y1 is not 4.9152
MHz, the baud rate will be scaled proportionally.
Install the jumper on jumper header W4 (Figure 2-4) pins 1 and 2 (factory
default) when an MC68HC908MR16/32 MCU is installed. Install the jumper on
pins 2 and 3 when an MC68HC(9)08MR4/8 MCU is installed.
Figure 2-3. MR16/32 I/O Baud Rate Selection Jumper (W3)
Figure 2-4. MCU Emulation Selection Jumper (W4)
Preparation and Installation
W3
W4
1
2
3
2
3
1
M68ICS08MR In-Circuit Simulator
MOTOROLA