HS7727KCM02H Renesas Electronics America, HS7727KCM02H Datasheet - Page 10

• Manufacturer Part Number: HS7727KCM02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America

Specifications of HS7727KCM02H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1.2
To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector
must be installed on the user system to connect the user system interface cable. When designing
the user system, refer to the recommended circuit between the H-UDI port connector and the
MCU. In addition, read the E10A emulator user's manual and hardware manual for the related
device.
Table 1.2 shows the type number of the E10A emulator, the corresponding connector type, and the
use of AUD function.
Table 1.2 Type Number, AUD Function, and Connector Type
Type Number
HS7727KCM02H, HS7727KCI02H
HS7727KCM01H, HS7727KCI01H
The H-UDI port connector has the 36-pin and 14-pin types as described below. Use them
according to the purpose of the usage.
1. 36-pin type (with AUD function)
2. 14-pin type (without AUD function)
4
The AUD trace function is supported. A large amount of trace information can be acquired in
realtime. The window trace function is also supported for acquiring memory access in the
specified range (memory access address or memory access data) by tracing.
The AUD trace function cannot be used because only the H-UDI function is supported. For
tracing, only the internal trace function is supported. Since the 14-pin type connector is
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user
system can be reduced.
Connecting the E10A Emulator with the User System
Connector
36-pin connector
14-pin connector
AUD Function
Available
Not available