DEMO908AP64 Freescale Semiconductor, DEMO908AP64 Datasheet - Page 3

• Manufacturer Part Number: DEMO908AP64
• Description: BOARD DEMO FOR 908AP64
• Manufacturer: Freescale Semiconductor
• Type: Microcontrollerr

Specifications of DEMO908AP64

• Contents: Board, CDs, Cable, Filter
• Processor To Be Evaluated: MC68HC908AP
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: HC08
• Core Sub-architecture: HC08
• Silicon Core Number: MC68HC908
• Silicon Family Name: HC08AP
• Kit Contents: Demo Board, Cables, Software, Guides
• Rohs Compliant: No
• For Use With/related Products: MC68HC908AP Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

D E M O 9 0 8 A P 6 4
CAUTIONARY NOTES
1) Electrostatic Discharge (ESD) prevention measures should be used when handling this
2) Axiom Manufacturing does not assume any liability arising out of the application or use of
3) EMC Information on the DEMO908AP64 module:
TERMINOLOGY
This development module uses option selection jumpers. A jumper is a plastic shunt that con-
nects 2 terminals electrically. Terminology for application of the option jumpers is as follows:
a) This product as shipped from the factory with associated power supplies and cables, has
b) This product is designed and intended for use as a development platform for hardware
c) In a domestic environment, this product may cause radio interference in which case the
d) Attaching additional wiring to this product or modifying the products operation from the
product. ESD damage is not a warranty repair item.
any product or circuit described herein; neither does it convey any license under patent
rights or the rights of others.
been verified to meet with requirements the FCC as a CLASS A product.
or software in an educational or professional laboratory.
user may be required to take adequate prevention measures.
factory default as shipped may effect its performance and cause interference with other
apparatus in the immediate vicinity. If such interference is detected, suitable mitigating
measures should be taken.
Jumper on, in, or installed - jumper is installed such that 2 pins are connected together.
Jumper off, out, or idle - jumper is installed on 1 pin only. It is recommended that jump-
ers be idled by installing on 1 pin so they will not be lost.
Cut-Trace – a circuit trace connection between component pads. The circuit trace may
be cut using a knife to break the default connection. To reconnect the circuit, simply in-
stall a suitably sized 0-ohm resistor or attach a wire across the pads.
3
J U N E
2 8 ,
2 0 0 4