PS7342-1A-A CEL, PS7342-1A-A Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/1/129/cel_sml.jpg)
PS7342-1A-A
Manufacturer Part Number
PS7342-1A-A
Description
SSR OCMOS FET 200MA NO 6-DIP
Manufacturer
CEL
Series
PS, OCMOSr
Datasheet
1.PS7342L-1A-E3-A.pdf
(14 pages)
Specifications of PS7342-1A-A
Circuit
SPST-NO (1 Form A)
Output Type
AC, DC
On-state Resistance
10 Ohm
Load Current
200mA
Voltage - Input
1.2VDC
Voltage - Load
0 ~ 400 V
Mounting Type
Through Hole
Termination Style
PC Pin
Package / Case
6-DIP (0.300", 7.62mm)
Load Voltage Rating
400 V
Load Current Rating
200 mA
Contact Form
Single Channel Form A (NO)
Output Device
MOSFET
Mounting Style
Surface
Relay Type
Solid State
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
<R>
RECOMMENDED SOLDERING CONDITIONS
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10309EJ02V0DS
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Two
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
PS7342-1A,PS7342L-1A
260˚C MAX.
220˚C
11