63811-7200 Molex Inc, 63811-7200 Datasheet - Page 3

• Manufacturer Part Number: 63811-7200
• Description: TOOL HAND CRIMP 14-18AWG
• Manufacturer: Molex Inc
• Series: PremiumGrade™, Sabre™r

Specifications of 63811-7200

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• Product: Crimping, Stripping & Cutting Tools & Drills
• Description/function: Sabre 7.5mm (Female)
• Fits Cable/wire: 18-14 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Rectangular Contacts, 14-18 AWG
• For Use With: WM18495 - CONN TERM MALE 18AWG TINWM18493 - CONN TERM FEMALE 14-16AWG TIN
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 063811-7200; 063811-7200-P; 0638117200; 0638117200-P; 63811-7200; 63811-7200-P; 638117200; 638117200-P; Q3519221; WM1618

Hand Crimp Tool for Sabre™ Flat Blade Crimp Terminals
Doc No. ATS-638117200
Revision: A
3. Press down on the wire stop on the locator as shown in Figure1. Insert the proper terminal into the proper nest opening. Make
4. Return the locator to its original position.
5. Insert the proper wire over the terminal. Gently touch the wire stop with the end of the wire. See Figure 3 and 4.
6. Compress the terminal by squeezing the tool handles until the ratchet mechanism cycle has been completed. Release handles to
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
7. Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on the wire. The
8. Visually inspect the crimped terminal for proper crimp
Note:
A crimp height chart is provided with this manual as Reference
Only. Due to the wide range of wires, strands, insulation
diameters, and durometers, actual crimp height measurements
may very slightly. An occasional, destructive, pull force test
should be preformed to check hand tool crimp. Pull Force value
must exceed the minimum pull force specifications listed.
sure when choosing the nest opening, it will correspond with the A, B or C profile on the hand tool.
open the jaws.
terminal locator can be in either position.
location.
TERMINAL
LOCATOR
CLOSED
Release Date: 02-12-07
Revision Date: 02-12-07
Figure 2
OPEN WIRE STOP
PUSH HERE TO
HANDLE
OPEN
UNCONTROLLED COPY
LOCATOR
WIRE IN TERMINAL
PARTIALLY
WIRES AGAINST
CLOSED
LOCATOR STOP
JAWS
TERMINAL
WIRE AGAINST
WIRE STOP
CONDUCTOR
PUNCH
CONDUCTOR ANVIL
Figure 3
Figure 4
INSULATION
INSULATION
ANVIL
PUNCH
WIRE
Page 3 of 6