58587-1 Tyco Electronics, 58587-1 Datasheet - Page 3

• Manufacturer Part Number: 58587-1
• Description: TOOL HAND CRIMP W/DIE 18-22AWG
• Manufacturer: Tyco Electronics

Specifications of 58587-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• For Use With/related Products: -
• Tool Type: -

4. CONTACT SUPPORT ADJUSTMENT
Rev
PRO-CRIMPER III Hand Crimping Tool Assembly 58587-1
Locator Support
Not Shown
12. To disassemble, close the tool handles until the
ratchet releases, remove the nut, the locator
assembly, the two die retaining screws, and the
four die retaining pins, and slide the anvils and
crimpers out of the tool jaws.
NOTE
1. Make a sample crimp and determine if the
contact is straight, bending upward, or bending
downward.
2. If adjustment is required, loosen the screw that
holds the contact support onto the locator
assembly.
NOTE
3. Place a contact with wire into the proper nest
and close the tool handles until the ratchet reaches
the sixth click, or until the contact support touches
the contact.
4. Slightly loosen the nut that holds the locator
assembly onto the tool frame.
5. Move the contact support as required to
eliminate the bending of the contact.
6. Tighten the nut and close the handles until the
ratchet releases.
Adjustment
Screw for
Contact
Support
B
i
i
The contact support is preset prior to shipment,
but minor adjustment may be necessary.
The ratchet has detents that create audible clicks
as the tool handles are closed.
Contact
Support
Locator
(Figure 3)
Tyco Electronics Corporation
Back of Tool
(Wire Side)
Figure 3
Wire
5. CRIMPING PROCEDURE
Refer to the table in Figure 1 and select wire of the
specified size and insulation diameter. Strip the wire
to the length indicated in Figure 1, taking care not to
nick or cut wire strands. Select an applicable contact
and identify the appropriate crimp section according
to the wire size markings on the tool. Refer to
Figure 3 and proceed as follows:
7. Remove and inspect the contact.
8. Make another sample crimp. If the contact is
straight, tighten the contact support screw. If the
contact is still being bent during crimping, repeat
the adjustment procedure.
NOTE
1. Hold the tool so that the back (wire side) is
facing you. Squeeze tool handles together and
allow them to open fully.
2. Holding the contact by the mating end, insert the
contact — insulation barrel first — through the front
of the tool and into the appropriate crimp section.
3. Place contact into the locator support and
position the contact so that the mating end of the
contact is on the locator side of the tool, and so
that the open “U” of the wire and insulation barrels
face the top of the tool. Carefully close the tool,
positioning the contact so that the movable locator
drops into the slot in the contact. Refer to Figure 3.
i
This tool is provided with a crimp adjustment
feature. Initially, the crimp height should be
verified as specified in Figure 4. Refer to Section
6, CRIMP HEIGHT INSPECTION, and Section 7,
CRIMP HEIGHT ADJUSTMENT, to verify crimp
height before using the tool to crimp desired
contacts and wire sizes.
Locator in Wire
Stop Slot
Contact
(Typ)
Locator
Support
Wire Inserted
to Stop
Strip Length
408-4206
3
of 5