122842-2 Tyco Electronics, 122842-2 Datasheet - Page 2

• Manufacturer Part Number: 122842-2
• Description: TOOL CHAMP CRIMPER .8MM 68POS
• Manufacturer: Tyco Electronics

Specifications of 122842-2

• Tool Type: Crimper Assembly
• For Use With: 91085-2 - TOOL MANUAL ARBOR PRESS
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• For Use With/related Products: -

3.1. Lower Tooling Assembly
3.2. Upper Tooling Assembly
4. TOOLING ADJUSTMENTS
The following adjustments are required during the
initial setup of the crimper assembly and when
changing cable size.
2 of 4
1. Remove the tool stop from the slide base of the
arbor frame assembly.
2. Slide the lower tooling assembly into the tracks
of the frame assembly slide base. The cable clamp
spring must be oriented to the left side of the slide
base as shown in Figure 1.
3. Re--install the tool stop and secure it with the
socket head cap screw.
1. Remove the upper tool mount (supplied with the
arbor frame assembly) by removing the two flat
head cap screws. Do not discard this tool mount.
2. Install the tool mount (supplied with the crimper
assembly) to the ram of the arbor frame assembly
and secure it with the flat head cap screws.
3. Position the crimper in the tool mount with the
longer offset to the right (as shown in Figure 1).
Secure crimper to tool mount with the socket head
cap screw.
Adjustment
Ring
Rear Tool
Stop
Cable
Ball Handle
Tyco Electronics Corporation
Figure 2
4.1. Cable Clamp Springs
The cable clamp springs can be adjusted for various
cable diameters by loosening the socket head cap
screws and re--positioning the cable clamp springs.
4.2. Crimp Height
To check crimp height, a test crimp should be made
(refer to Section 5); then, measure the crimp height of
the backshell ferrule. Refer to the appropriate
application specification (114--series) for the crimp
height. If the actual crimp height does not conform to
that dimension, proceed as follow:
5. CRIMPING PROCEDURE
Refer to Figure 2 and proceed as follows:
1. Loosen the setscrew on the adjustment ring.
Turn the adjustment ring CLOCKWISE to increase
crimp height or COUNTERCLOCKWISE to
decrease crimp height.
2. Re--tighten the setscrew.
1. Using the ball handle, slide the lower tooling
assembly out from under the ram of arbor frame
assembly.
2. Position the connector backshell assembly in
the support block.
Support
Block
Ram
Cable Clamp
Spring
Connector
Handle
Lower Tooling
Assembly
Tool Stop
Rev C