58436-1 Tyco Electronics, 58436-1 Datasheet

DIESET HEXCRIMP RG58, 62, 59

58436-1

Manufacturer Part Number
58436-1
Description
DIESET HEXCRIMP RG58, 62, 59
Manufacturer
Tyco Electronics
Series
Pro-Crimper™ IIIr
Type
Die Setr
Datasheets
1.1673606-1.pdf (8 pages)
2.58425-2.pdf (4 pages)
3.58436-1.pdf (3 pages)

Specifications of 58436-1

Connector Type
BNC, TNC
Crimp Handle
A9996-ND
Crimp Or Cable Size
RG/U-58, 59, 62
Rohs Compliant
NA
Product
Tool Component
Fits Cable/wire
RG58/59 Hex IS9159
Lead Free Status / RoHS Status
Not applicable / Not applicable
For Use With
50 Ohm RF Connectors
Lead Free Status / RoHS Status
Not applicable / Not applicable
Other names
A9994
This instruction sheet covers the use and
maintenance of Crimping Dies 58425–[ ] and
58436–[ ] (in their various configurations – denoted by
the dash number following the base part number),
used in PRO–CRIMPER* Hand Tool Frame
354940–1. The dies crimp 75–Ohm Hex Crimp BNC
and TNC plug connectors onto coaxial cable.
Reasons for reissue of this sheet are provided in
Section 7, REVISION SUMMARY.
E
Die Assemblies
58425-[ ] and 58436-[ ]
i
All dimensions are in millimeters [with inches in
brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Figure 1
Each die assembly consists of an indenter die and an
anvil die. When closed, the dies form either two or
three crimping chambers (depending on type) which
crimp the center contact and ferrule of the connector
onto the coaxial cable. Each die is held in the tool by
a single screw.
1. Close the tool handles until the ratchet releases
and then allow them to open fully.
2. See Figure 1 for normal orientation of the dies.
Insert the dies inside the tool jaws and align the
retaining screw holes.
3. Thread the retaining screws into the holes and
carefully close the tool handles. Tighten the screws
with the appropriate hex wrench.
Hand Tool Frame
354940-1

58436-1 Summary of contents

Page 1

... This instruction sheet covers the use and maintenance of Crimping Dies 58425–[ ] and 58436–[ ] (in their various configurations – denoted by the dash number following the base part number), used in PRO–CRIMPER* Hand Tool Frame 354940–1. The dies crimp 75–Ohm Hex Crimp BNC and TNC plug connectors onto coaxial cable ...

Page 2

... If damage or abnormal wear is evident, the dies must be replaced. Refer to Section 6, PARTS REPLACEMENT. Crimping Ferrule Crimping Die (Ref) Typical RF Connector (Ref) Tyco Electronics Corporation Flange on End of Contact Crimping Die Figure 3 Shoulder on Connector Body Butts Against Die Ferrule on Anvil of Crimping Die ...

Page 3

... Die 58425-[ ] 58425-1 1.07 [.042] (Square) 58425-2 1.07 [.042] (Square) 58425-3 1.07 [.042] (Square) 58436-1 --- 58436-2 --- 58436-3 --- 58436-4 --- The die assembly will perform correctly as long as: (1) the product specified is correct for the application, (2) the specific die assembly is used, (3) the die ...