58063-2 Tyco Electronics, 58063-2 Datasheet - Page 3
![HEAD ASSEMBLY TOOL FOR D-SUB CON](/photos/9/90/99022/58063-2_sml.jpg)
58063-2
Manufacturer Part Number
58063-2
Description
HEAD ASSEMBLY TOOL FOR D-SUB CON
Manufacturer
Tyco Electronics
Series
AMPLIMITE® HDE-20r
Type
Terminating Headr
Specifications of 58063-2
Connector Type
D-Sub Connector Contacts
Crimp Handle
A2031-ND, 58075-1-ND, 58338-1-ND, 931800-1-ND
Crimp Or Cable Size
20-30 AWG
Product
Tool Component
Lead Free Status / RoHS Status
Not applicable / Not applicable
For Use With
58075-1 - TOOL HANDLE PNEUMATIC W/O HEAD931800-1 - ELEC PWR UNIT W/O F/TRK OR HD58338-1 - PWR BENCH ASSEMBLY W/O HEADS
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
A2032
for the head. One inspection per month is the
recommended frequency; however, operator training
and skill, amount of use, working conditions, and
established company standards are all factors to be
considered in establishing inspection frequency.
5.2. Daily Maintenance
5.3. Periodic Maintenance
Rev B
Head During Termination
AMPLIMITE HDE- - 20
Receptacle Connector
Damaged Housing—
Tight or Too Loose in
Connector Was Too
1. Remove dust, moisture, and other contaminants
with a clean, soft brush or lint--free cloth. DO NOT
use objects that could damage the head.
2. Make sure that all components are in place and
properly secured.
3. Make sure that the mechanisms inside the head
function smoothly.
1. Remove any accumulated film with a suitable
cleaning agent that will not affect plastic.
Wire Was Not Inserted
Deep Enough During
0.51 mm
[.020 in.]
Min
Termination
Correct
A
Arms of Insulation Support
Barrel Completely Closed
A
Tyco Electronics Corporation
Termination Inspection
Wire Was Inserted With
Too Much Force During
Section A- - A
Centerline of
Conductor
Termination
Incorrect
Figure 4
0.84+0.10 mm
[.033+.004 in.]
6. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 5.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
717--986--7605, or write to:
For customer repair service, call 1--800--526--5136.
2. Check for chipped, cracked, worn, or broken
areas on the head. If damage is evident, repair or
replace the head.
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
Acceptable
Wire Was Not Inserted
Straight Before
Termination
Arms of Insulation Support
Barrel Partially Closed
Wire Was Not Fully
Inserted Before
Termination
3 of 4