318452-2 Tyco Electronics, 318452-2 Datasheet - Page 5

• Manufacturer Part Number: 318452-2
• Description: PROCRIMP DIE ASSY COMM BNC
• Manufacturer: Tyco Electronics
• Type: Dier

Specifications of 318452-2

• Connector Type: BNC
• Crimp Handle: Tyco/AMP 318452-1
• Crimp Or Cable Size: Belden 9907, 89907, Comm/Scope 2104
• Product: Tool Component
• Description/function: BNC O Crimp Commercial
• Features: Die for Pro-Crimper
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With: 50 Ohm RF Connectors
• Other names: A24781

Rev
PRO-CRIMPER III Hand Crimping Tool Assembly 318452-1
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
higher–numbered setting. If a looser crimp is
required, rotate the adjustment wheel
CLOCKWISE to a lower–numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the crimp height is acceptable, secure the
lockscrew. If the dimension is unacceptable,
remove lockscrew and continue to adjust the
ratchet, and again measure a sample crimp.
B
Ratchet
Adjustment
Wheel
Lockscrew
(Typ)
Screwdriver
Figure 7
Tyco Electronics Corporation
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
9. DIE REPLACEMENT
Customer–replaceable parts are shown in Figure 8.
Spare parts or the die assembly should be stocked
and controlled to prevent lost time when die
replacement is necessary.
In addition a PRO–CRIMPER III Hand Crimping Tool
Repair Kit 679221–1 is available. The repair kit
includes a replacement nut and a variety of pins,
rings, screws, and springs.
Order replaceable parts through your Tyco
Electronics representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
10. REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes were made:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG PA 17105–3608
S The TE logo was applied;
S The PRO–CRIMPER II hand tool was changed
to the PRO–CRIMPER III hand tool;
408-4219
5
of 6