1-47387-0 Tyco Electronics, 1-47387-0 Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/6/687/tyco_electronics_sml.jpg)
1-47387-0
Manufacturer Part Number
1-47387-0
Description
TOOL HEAD CRIMP 16-14AWG PIDG
Manufacturer
Tyco Electronics
Series
PIDG™, Plasti-Grip™r
Datasheet
1.1-47386-0.pdf
(9 pages)
Specifications of 1-47387-0
Connector Type
Terminals and Splices
Crimp Handle
1213563-1, 1213804
Crimp Or Cable Size
14-16 AWG
Lead Free Status / RoHS Status
Not applicable / Not applicable
3.2. Installation
3.3. Removal
Remove the quick pins from the crimping head; then
remove the crimping head from the tool holder.
4. CRIMPING PROCEDURES
4.1. Terminal Crimping Procedure
Rev
DANGER
DANGER
DANGER
DANGER
1. Remove quick pins from the adapter assembly.
Refer to Figure 1.
2. Insert crimping head into the adapter assembly.
3. After the crimping head is properly aligned,
insert the quick pins through the two holes in the
adapter and through the holes in the crimp head.
NOTE
1. Strip wire to dimensions shown in Figure 2. DO
NOT nick wire strand or use wires with nicked or
missing conductor strands.
2. Center the terminal or splice wire barrel in the
appropriate crimp chamber. See Figure 3.
3. Depress the trigger to advance the moving ram.
This closes the crimp jaws in order to hold the
terminal in place. DO NOT deform the wire barrel.
4. Insert stripped wire into terminal until the end of
the conductor butts against the locator as shown in
Figure 3.
A
To avoid personal injury, be sure to exercise
extreme caution when handling the crimp tool.
Avoid accidentally depressing the trigger control
when installing or removing crimp heads.
DO NOT operate the battery tool without the
proper crimping head installed. After crimping
head is installed, make sure that the quick pins
are properly inserted to avoid personal injury and
damage to the tool.
The quick pins will snap" into position when they
are properly inserted.
To avoid personal injury, ALWAYS disconnect the
battery from the tool before removing crimping
head.
To avoid personal injury, ALWAYS keep fingers
clear of crimping jaws when operating the tool.
Never place anything within the crimping jaws
except Tyco Electronics terminals or splices.
PIDG and PLASTI-GRIP Terminal and Splice Crimping Heads
4.2. Butt Splice Crimping Procedure
Locator
C"
C"
5. Activate the tool to complete the crimp. The
crimp tool automatically returns to the first position
of the cycle when the crimp is complete.
6. Refer to Section 5 and Figure 6 for crimp
inspection.
1. Strip wire to dimensions shown in Figure 2. DO
NOT nick wire strand or use wires with nicked or
missing conductor strands.
2. Position splice between crimping jaws so that
the window indent slides under the locator of crimp
head. See Figure 4A.
3. Depress the trigger to advance the moving ram.
This closes the crimp jaws to hold the terminal in
place. DO NOT deform the wire barrel.
4. Insert stripped wire into wire barrel of splice until
the end of the conductor is against the splice wire
stop. See Figure 4A.
5. Activate tool to complete the crimp.
Terminal Tongue
Positioned Under
Locator
B"
B"
PIDG and PLASTI-GRIP Terminals
PLASTI-GRIP
Terminal
Wire Barrel Against Locator
Terminal
PIDG
Figure 3
Locator
C"
B" Equals Wire Barrel
C" Equals Insulation Barrel
B"
PIDG
Nylon Insulation
Restricting
Terminal
408-10029
3
of 9