1-46988-0 Tyco Electronics, 1-46988-0 Datasheet - Page 2

• Manufacturer Part Number: 1-46988-0
• Description: TOOL HEAD CRIMP 14-16AWG STRATO
• Manufacturer: Tyco Electronics
• Series: Strato-Therm™r

Specifications of 1-46988-0

• Connector Type: Terminals and Splices
• Crimp Handle: 1213563-1, 1213804
• Crimp Or Cable Size: 14-16 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

inserts the stripped wire, the tool is activated to crimp
the terminal or splice to the wire.
NOTE:
3. HEAD INSTALLATION AND REMOVAL
3.1. Head Selection
3.2. Installation
Terminal Tongue
Through Slot in
Locator
2
1-46673-0
1-46988-0
DANGER
DANGER
1-46673-1
of 6
NOTE
1. Remove quick pins from the adapter assembly.
Refer to Figure 1.
2. Insert crimping head into the adapter assembly.
3. After the crimping head is properly aligned,
insert the quick pins through the two holes in the
adapter and through the holes in the crimp head.
Edge of Wire Barrel
Sleeve Resting
Against Locator
TOOL
TOOL
D
For wires with thin-wall insulation.
D
SIZE (AWG)
22 16
22-16
16-14
Figure 2
WIRE
Insulation
Barrel Sleeve
STRIP LENGTH
[ 203- 234]
[.203-.234]
5 16 5 94
5.16-5.94
STRATO-THERM Crimping Heads
Wire Barrel
Sleeve
Terminal Crimp
Figure 3
3.3. Removal
Remove the quick pins from the crimping head; then
remove the crimping head from the tool holder.
4. CRIMPING PROCEDURES
4.1. Crimping Procedure
DANGER
DANGER
NOTE
1. Strip wire to dimensions shown in Figure 2. DO
NOT nick wire strand or use wires with nicked or
missing conductor strands.
2. Push the locator up and, from the FRONT side
of the tool, insert the terminal or splice wire barrel
sleeve into the crimping jaws making sure that the
edge of the wire barrel sleeve rests against the
locator. See Figures 3 and 4.
3. Depress the trigger to advance the moving ram.
This closes the crimp jaws in order to hold the
terminal in place. DO NOT deform the wire barrel.
4. Insert wire conductor through the insulation
barrel sleeve and into the wire barrel sleeve until it
is flush with the outer edge of the wire barrel
sleeve.
NOTE
Back Side of Tool
Insert Wire Conductor
Through Insulation
Barrel Sleeve and into
Wire Barrel Sleeve
408-10033
Rev
A