68248-1 Tyco Electronics, 68248-1 Datasheet - Page 2

• Manufacturer Part Number: 68248-1
• Description: TOOL DIE P-G 68250-1 6AWG
• Manufacturer: Tyco Electronics

Specifications of 68248-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

4. CRIMPING PROCEDURE
2
Crimping Dies 68247-1, 68248-1, and 1213098-1
2. Remove front applicator guard, then depress
terminal extractor and pivot it away from crimping
die holder (see Figure 2).
3. With tape release lever UP, remove holding
screws and dies.
1. Strip wire to the dimensions listed in Figure 1.
Do not cut or nick the wire strands.
2. Place main power switch in the ON position and
be sure tape release lever is lowered.
3. Insert stripped wire into terminal wire barrel until
wire conductor butts against the stop. See
Figure 3.
4. Holding wire in place, depress and release foot
switch. The machine will cycle and crimp the
terminal.
Figure 3
5. CRIMP INSPECTION
Inspect crimped terminals by checking the features
described in Figure 4. Use only the terminals that
meet the conditions shown in the “ACCEPT” column.
5. Remove crimped terminal.
6. Inspect the crimp according to Section 5.
Figure 4
ACCEPT
REJECT
408-2592
C