576714 Tyco Electronics, 576714 Datasheet - Page 2

• Manufacturer Part Number: 576714
• Description: MATRICE DIE ASSY 16AWG
• Manufacturer: Tyco Electronics

Specifications of 576714

• Lead Free Status / RoHS Status: Not applicable / Not applicable

2. Close the tool handles until the terminal is held
firmly in place.
3. Insert a stripped wire into the terminal until the
wire butts against the locator.
4. Complete the crimp by closing the handles until
the CERTI–CRIMP* hand crimping tool ratchet
control releases.
5. The handles can now be opened and the
crimped item may be removed.
1. The insulation crimping section of the moving
die has three crimp positions: 1–Tight, 2–Medium,
3–Loose.
2. Turn both insulation crimp adjustment spacers
so that they fit into the notch in the side of the die.
See Figure 1. This is the No. 3 or loose position.
(The moving die must be removed from the die
holder to make this adjustment if the die has
already been installed).
Finished Crimp
Figure 2
Note that the dies and terminals are color–coded
according to wire size for easy identification. See
Figure 2. When the terminals are properly crimped in
the correct dies, 1 dot or 2 dots (depending on wire
size), will appear embossed on the top and bottom of
the terminal. See Figure 2.
NOTE:
3. Insert the die into the die holder.
4. Turn the die holding screw enough to hold the
die firmly in place. The die holding screw will be
tightened after completing steps 5 and 6.
5. Insert the UNSTRIPPED wire into ONLY the
insulation barrel position of the terminal.
6. Make a test crimp (refer to Paragraph 2.3 for
crimping procedure). Close the die on the terminal
and hold the die in the bottomed position. Tighten
the die holding screw while the dies are bottomed,
then complete the crimping cycle.
7. Remove the terminal from the dies, and check
the insulation grip as follows: Bend the wire back
and forth ONCE. The terminal sleeve should retain
the grip on the wire insulation.
8. If the wire pulls out, use the following procedure
to set the insulation crimp adjustment to the next
tighter position: First, remove the die from the die
holder. Then, turn the lower insulation adjustment
spacer 90 so that it fits between the die and the
die holder. The No. 2 will appear on the corner of
the spacer. Repeat the test crimp, and adjust the
die as necessary until the desired insulation grip is
obtained.
9. With both adjustment spacers placed between
the die and the die holder, the die is set in its
tightest insulation crimping position. The No. 1 will
appear on the corner of the top spacer.
Figure 3