58449-1 Tyco Electronics, 58449-1 Datasheet - Page 3

• Manufacturer Part Number: 58449-1
• Description: DIE HOLDER ASSY AMPLIMITE
• Manufacturer: Tyco Electronics
• Type: Die Holderr

Specifications of 58449-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

Rev B
4. Lower the ram to engage the upper die holder
subassembly with the lower die holder
subassembly.
5. Secure the ram adapter to the ram by tightening
the four socket head cap screws (installed in
Step 2).
6. Connect the air supply to raise the ram.
NOTE
Front Guard
Assembly
i
Lower Die
Holder
If the locating holes in the guide block do not line
up with the pins in the upper die holder
subassembly, loosen the screws securing the
lower subassembly to the base plate of the power
unit. Re- - adjust the tooling so that the locating
holes and pins are properly aligned; then
re- - tighten the screws to secure the lower
subassembly to the base plate of the power unit.
Make sure the lower subassembly is against the
stop before securing the screws.
Tool Stop
Connector Support
Bracket
Front Guard
Assembly
Upper Die
Holder
Lower Die
(Anvil) (Ref)
Tyco Electronics Corporation
Figure 3
4. DIE ASSEMBLY INSTALLATION AND REMOVAL
(See Figure 3)
4.1. Installation
Select the appropriate die assembly referenced on
the instruction sheet for the connector, then proceed
as follows:
DANGER
1. Slide the lower die holding plate out from under
the ram.
2. Install the upper die (indenter) into the upper die
holder and secure it with the cap screw provided
with the die assembly.
NOTE
i
Make certain that the air supply to the power unit
is turned OFF before installing the die assembly.
This screw can be accessed using the .19- - in.
diameter hole on the left side of the fixed guard.
Locating Hole(s)
of Guide Block
Pin(s)
Upper Die
(Indenter) (Ref)
3 of 8