1-48070-0 Tyco Electronics, 1-48070-0 Datasheet - Page 4

• Manufacturer Part Number: 1-48070-0
• Description: TOOL HEAD BAT 26-22AWG CRIMP DG
• Manufacturer: Tyco Electronics
• Series: Diamond Grip™r

Specifications of 1-48070-0

• Connector Type: Terminals and Splices
• Crimp Handle: 1213563-1, 1213804
• Crimp Or Cable Size: 22-26 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

Each crimping head is thoroughly inspected before
packaging. Since there is the possibility of crimping
head damage during shipment, new crimping heads
should be inspected immediately upon arrival at your
facility.
6.1. Daily Maintenance
Tyco Electronics recommends that each operator be
responsible for the following steps of daily
maintenance:
4
1
2
3
4
5
6
of 6
3. The degree of operator skill.
4. The presence of abnormal amounts of dust and
dirt.
5. Your own established standards.
Insulation barrel is in firm contact with wire insulation.
Wire fully inserted.
Wire size is within wire range stamped on terminal
tongue or splice.
Crimp centered on wire barrel.
End of conductor is flush with, or extends slightly be
yond end of terminal wire barrel.
End of conductor against wire stop of splice.
1
conductor must at least be flush with, or extend
NOTE: If conductor is not against wire stop,
beyond wire barrel of splice.
2
1
4
ACCEPT
4
6
3
4
1
Wire Range
Stamped Here
5
DIAMOND GRIP Terminal and Splice Crimping Heads
5
2
Crimp Inspection
Figure 6
Terminals
Splices
1
2
3
4
5
6
7
DANGER
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a lint–free cloth. Do
NOT use objects that could damage the head.
2. Make sure that all pins, rings, and other
components are in place and secure.
3. Make certain all surfaces are protected with a
thin coat of any good SAE 20 motor oil. Do NOT oil
excessively.
4. When the head assembly is not in use, store it
in a clean dry, area.
2
Wire insulation extruded. (Insulation crimp too tight).
Wire not fully inserted.
Wire size is not within wire range stamped on terminal
tongue or splice.
Crimp not centered on wire barrel. Product was not
butted against locator.
End of conductor is not flush with or extending slightly
beyond end of wire barrel. (Check for correct strip length.)
Excessive flash (wrong terminal or splice combination
used, or damaged dies).
Nicked or missing conductor strands.
Wire Range
Stamped Here
5
7
To avoid personal injury and damage to the tool,
make sure quick pins are properly inserted.
5
Wire Range
Stamped Here
1
3
3
1
REJECT
6
6
4
408-10031
4
Rev
A