5-1437514-5 Tyco Electronics, 5-1437514-5 Datasheet - Page 2

• Manufacturer Part Number: 5-1437514-5
• Description: TOOL HAND SPRING LOADED
• Manufacturer: Tyco Electronics
• Series: HOLTITEr
• Type: Hand Tool, Spring Loadedr

Specifications of 5-1437514-5

• Product: Crimping, Stripping & Cutting Tools & Drills
• Lead Free Status / RoHS Status: Not applicable / Not applicable

2.3. Drawings
Customer Drawings for specific products are available from the service network. The information contained in
Customer Drawings takes priority if there is a conflict with this specification or with any other technical
documentation supplied by TE.
2.4. Specifications
Product specification 108--1979 provides product performance requirements and test information.
2.5. Instructional Material
The following list includes available instruction sheets (408--series) that provide assembly procedures for
operation, maintenance and repair of tooling; and customer manuals (409--series) that provide setup,
operation, and maintenance of machines.
Document Number
3. REQUIREMENTS
3.1. Storage
3.2. Material
All sockets are made of beryllium--copper with gold, tin/lead, or tin plating.
3.3. PC Boards
2 of 7
408--3295
408--6732
408--6923
408--7777
408--9816
409--5626
A. Ultraviolet Light
Prolonged exposure to ultraviolet light may deteriorate the chemical composition used in the socket.
B. Shelf Life
The sockets should remain in the shipping containers until ready for use to prevent deformation to the
sockets. The sockets should be used on a first in, first out basis to avoid storage contamination that could
adversely affect signal transmissions.
C. Chemical Exposure
Do not store sockets near any chemicals listed below, as stress corrosion cracking in the sockets may
occur.
Alkalies
Amines
A. Material and Thickness
Contact the Product Information number listed at the bottom of page 1 for suitability of other board
materials or thicknesses.
B. PC Board Hole Dimensions
The socket holes in the pc board must be precisely drilled to ensure proper placement and optimum
performance of the socket. The drilled holes must be on 2.54 mm [.100 in.] centerlines (minimum). The
dimensions provided in Figure 2 must be observed when preparing a pc board for AUGAT HOLTITE
Sockets.
1. Board material will be glass epoxy (FR--4, G--10).
2. Board thickness shall be 0.75 mm [.030 in.] minimum for all socket sizes except for 12P which is used
in a 1.27 mm [.050 in.] minimum thick pc board.
Ammonia
Carbonates
Document Title
Preparing Reel of Contacts for Application Tooling
Pneumatic Auto--Cycle Unit 91112--3
Manual Arbor Frame Assembly 58024--1
Manual Arbor Frame Assembly 91085--2
Handling of Reeled Products
SM--3 Machine No. 814700--[ ]
Citrates
Nitrites
Phosphates Citrates
Sulfur Nitrites
Sulfur Compounds
Tartrates
114- 13033
Rev B